Abstract:In order to reduce material costs, a simple and economical method without the use of strain gages was chosen, which is not widespread in practical implementations due to the high spread of the characteristic determined and its instability. It is based on the three-point transverse bending of specimens and measuring the deflection under the load applied. In this case, the shear modulus is calculated in two different ways. The tests were carried out on isotropic and on three types of composite materials with different reinforcement schemes. The control of the results obtained was carried out by testing similar samples in tension and bending by other proven methods. The main factors preventing the obtaining of stable and reliable values of shear moduli were established, one of which is the neglect of angular displacements of cross sections of the sample during calculation of the desired characteristics. It is shown that both the ways give very underestimated values of shear modulus for both isotropic and composite materials, with a very significant spread, which does not allow one to use the method considered in the presented form without corrections. It was established, that deflection under the load is determined by the rotation angles of sample cross sections and by the span, and its value is equal to the product of the maximal cross-sectional rotation angle and one third of the span length. It is shown that, taking into account the identified factors and some adjustment, this method is suitable for determining the shear modulus by the first or second way for both isotropic and composite materials.

Estimating Young’s Modulus of Materials by a New Three-Point Bending Method

On Measuring the Dynamic Elastic Modulus for Metallic Materials Using Stress Wave Loading Techniques

Research on Measurement of Material Fatigue Properties by New Simply Supported Bending Test Device

A New Method For Calculating Notch Tip Stresses And Strains Based On Neuber Method And Esed Method Under Multiaxial Loading

An improved energy method for determining Young’s modulus by instrumented indentation using a Berkovich tip

ELASTIC MODULI AND MATERIAL EFFICIENCY OF ALUMINUM HONEYCOMB CORES

Three-point Bending Young's Modulus of Nanowires

Estimation of Mechanical Properties of Aluminum Alloy Based on Indentation Curve and Projection Area of Contact Zone

Springback Prediction Model Considering the Variable Young’s Modulus for the Bending Rectangular 3A21 Tube

7A04-T6 High-Strength Aluminium Alloy SHS and RHS Beams under Pure Bending—testing, Modelling and Design Recommendations

A FEM-based Direct Method for Identification of Young’s Modulus and Boundary Conditions in Three-Dimensional Linear Elasticity from Local Observation

Method for Determining the Shear Moduli of Composite Materials from Experiments in the Three-Point Transverse Bending

A New Method for an Old Topic: Efficient and Reliable Estimation of Material Bulk Modulus

Characterization of Mechanical Properties of 3-D–printed Materials Using the Asymmetric Four-Point Bending Test and Virtual Fields Method

Evaluation of the effectiveness of representative methods for determining Young’s modulus and hardness from instrumented indentation data

Bending deformation behavior and characterization method of flexural stiffness of composite tubes under four-point bending tests

An investigation on springback of L-bending sheet metal forming based on nonlinear elastic unloading

Experimental study on variation law of Young's modulus and plastic deformation

Development of a new model for plane strain bending and springback analysis

Measurement of the Flexural Modulus of Chopped Carbon Fiber Tape Reinforced Thermoplastic with Short Beams

Estimation of the elasto-plastic properties of metallic materials from micro-hardness measurements