Abstract:The microstructure, stress rupture properties and deformation mechanisms of a new alloy during long-term aging were investigated. The microstructure evolution mainly included the coarsening of gamma' phase and the precipitation of eta phase. During aging at 700 degrees C, 750 degrees C and 800 degrees C, the coarsening rate k of gamma' phase was about 7.818 nm(3)/h, 42.927 nm(3)/h and 178.226 nm(3)/h, respectively. The activation energy Q for gamma' coarsening was about 279.98 kJ/mol, which meant that element diffusion controlled the coarsening of gamma' phase. After aging at 750 degrees C for 3000 h and 800 degrees C for 2000 h, a new needle-like eta phase was precipitated near GBs and around MC carbides, then grew into the grain interiors. The quantity of eta phase increased with the increase of aging time. With the growth of eta phase, gamma' depleted zones were found around eta phase. This was principally because both gamma' phase and eta phase were enriched in Ni and Ti, and the growing up of I phase absorbed gamma' phase. After aging at 700 degrees C for 300-3000 h and 750 degrees C for 300-2000 h, the stress rupture life at 750 degrees C/430 MPa remained at a high level and most of them were higher than 100 h. That was because the slightly grown-up gamma' phase acted as strong obstacles to the dislocation motion, Orowan bypassing combing stacking fault shearing acted as the dominant mechanism during stress rupture deformation. After aging at 750 degrees C and 800 degrees C for 3000 h, the stress rupture life decreased to 45.7 h and 7.68 h, respectively. One reason was that the seriously grown-up gamma' phase was very hard to impede the dislocation motion, almost all gamma' phases were cut by dislocations with leaving stacking faults inside them during stress rupture deformation. The other reason was that needle-like eta phase promoted dislocation pile-up and contributed to the nucleation of micro-cracks, meanwhile the gamma' depleted zones could be conductive to the propagation of micro-cracks.

Evolution of the microstructure and microhardness of a new wrought Ni–Fe based superalloy during high temperature aging

Microstructural Stability of Long-Term Aged Wrought Ni–Fe-based Superalloys

Effects of Microstructure Evolution on the Deformation Mechanisms and Tensile Properties of a New Ni-base Superalloy During Aging at 800 °C

Investigation of Precipitation Behavior of a Novel Ni-Fe-Based Superalloy during High-Temperature Aging Treatment

Effect of Heat Treatment on the Microstructure and Fracture Behaviors of a Ni–Cr–Fe Superalloy

Microstructural Evolution and Hardness of a Heat Resistant Alloy During Long Term Aging at 700 °C

Microstructure and Mechanical Properties of a New Ni-Cr-Fe-W-Al Alloy for Advanced Ultra-Supercritical Power Plants

Effect of Long-Term Aging on Microstructural Stability and Tensile Deformation of a Fe–Ni-based Superalloy

Influence of thermal exposure on microstructural stability and tensile properties of a new Ni-base superalloy

Microstructure Optimization for Higher Strength of a New Fe–Ni-based Superalloy

The Effect of Long-Term Aging on the Microstructure and Properties of a Novel Nickel-Based Powder Superalloy FGH4113A

Effects of Long Term Thermal Exposure on Microstructure and Mechanical Property Evolution of a New Wrought Ni–Fe Based Superalloy

Microstructure Evolution and Mechanical Property of Cu-15Ni-8Sn-0.2Nb Alloy During Aging Treatment

Impact of Aging Temperature on the Performance of a Nickel-Iron-Based Superalloy

The microstructure evolution and its effect on the mechanical properties of a hot-corrosion resistant Ni-based superalloy during long-term thermal exposure

Effect of Long-Term Aging on the Microstructure, Stress Rupture Properties and Deformation Mechanisms of a New Cast Nickel Base Superalloy

Thermal Stability of GH4065A Superalloy Based on Microstructural and Performance Evolution Following Long-Term Aging

The Effect of Fe and Cr on the Microstructure Evolution and Mechanical Properties of GH2107 Superalloy during Long-Term Aging

Microstructure Evolution and Mechanical Performance of Nickel Based Superalloy C1023 at Elevated Temperatures

Microstructure and Mechanical Properties of Cast Cu-15Ni-8Sn Alloy

Evolution of Microstructure, Mechanical and Corrosion Properties of Fe–13Cr–4Al-1.5Nb Alloy Aged at 450 °C