Abstract:The continuous development and application of laser technology, and the increasing energy and power of laser output have promoted the development of various types of laser optical systems. The optical components based on quartz materials are key components of high-power laser systems, and their quality directly affects the load capacity of the system. Due to the photothermal effect when the laser interacts with the quartz material and generates extremely high temperatures in a short period of time, it is impossible to experimentally solve the phenomena and physical mechanisms under extreme conditions. Therefore, it is very important to select a suitable method to investigate the thermal effect of intense laser interaction with quartz materials and explain the related physical mechanism. In this study, a three-dimensional quarter-symmetric laser heating quartz material geometry model by using nonlinear transient finite element method was established, and its transient temperature field distribution of the quartz material after being heated by a 1,064 nm continuous laser was investigated. In addition, the influence of different laser parameters (laser spot radius, heat flux and irradiation time), material parameters (material thickness, material absorption rate of laser) on the thermal effect of heating quartz material were also studied. When the laser heat flux is 20 W/cm2, the diameter of the laser spot is 10 cm, the irradiation time is 600 s and the thickness is 4 cm, the temperature after laser heating can reach 940.18°C, which is far lower than the melting point. In addition, the temperature maximum probes were set at the overall model, spot edge and rear surface respectively, and their temperature rise curves with time were obtained. It is also found that there is a significant hysteresis period for the rear surface temperature change of the quartz material compared with the overall temperature change due to heat conduction. Finally, the method proposed can also be applied to the laser heating of other non-transparent materials.

Heat Exchange Model in Absorption Chamber of Water-Direct-absorption-typed Laser Energy Meter

Study on the Influence of the Response Characteristics of A Temperature Sensor on the Measurement Accuracy of A Water-Absorption-Based High-Energy Laser Energy Meter

Theoretical Analysis of Thermal-Lensing Effect in a High Power Exciplex Pumped Cs Vapor Laser.

Modeling of Three-Dimensional Exciplex Pumped Fluid Cs Vapor Laser with Transverse and Longitudinal Gas Flow

Phase transition model of water flow irradiated by high-energy laser in a chamber

Modeling of Steady-State Temperature Distribution in Diode-Pumped Alkali Vapor Lasers: Analysis of the Experimental Results

Modeling of Kinetic and Thermodynamic Processes in a Flowing Exciplex Pumped Alkali Vapor Laser

Theoretical Simulation on Exciplex Pumped Rb Vapor Laser.

Technologies and Development Trends of Directly Measuring High Energy Laser Energy

Volume absorption laser energy meter for high energy laser by water absorption

Thermal Effects in High-Power Double Diode-End-Pumped Cs Vapor Lasers

Electro-optical Equivalent Calibration Technology for High-Energy Laser Energy Meters

A Method to Eliminate the Effect of Sound Path Length Change of Ultrasonic Heat Meter

Water jet guided high-power laser energy transmission loss analysis

Modeling Analysis and Experimental Study of a Temperature-difference Type Heat Flux Meter

Molten pool air-liquid interface in high-power laser manufacturing: Evolution law and energy absorption characteristics

A mathematical model with experiments of single effect absorption heat pump using LiBr–H2O

New Heat Source Model for Accurate Estimation of Laser Energy Absorption Near Free Surface in Selective Laser Melting

An Microcosmic Absorption Model For Absorber In Solar Driven Absorption Heat Pump

Research On Temperature Measurement Technology For Graphite-Cone-Absorption-Cavity Absolute Calorimeter

Simulation study on the thermal effect of continuous laser heating quartz materials