Abstract:Bamboo-concrete composite (BCC) beams are newly-innovated products used for floor system which synergistically utilizes bamboo and concrete components. These composite beams at cur-rent technology belong to the beam characterized with partial composite action due to the ex-istence of relative slip between bamboo segment and concrete slab. Existing investigations have demonstrated that the load bearing capacity of BCC beams depends on their bending stiffness; however, very limited prediction models are available to accurately estimate the bending stiffness of BCC beams. At present, the bending stiffness of BCC beams is predicted with the help of gamma-method in Eurocode 5-Part 1-1, and available studies have demonstrated that this method overestimates the bending stiffness of BCC beams. To this end, this paper presents a novel explicit model characterized with mechanism and data mining to predict the bending stiffness of BCC beams under short-term loads. Three steps were performed to achieve the aforementioned research objective. The first step was to introduce the axial force transfer coefficient into the equilibrium equations of internal force for bamboo segment and concrete slab. Secondly, the bending stiffness of BCC beams was established by taking into account the effect of relative slip with the help of existing experimental results from the interfacial shear test and flexural test. Finally, the proposed model was validated by comparing with flexural performance results of BCC beams collected from available literature as well as those obtained from gamma-method. The comparative results show that: i) the predicted bending stiffness of BCC beams is much closer to tested ones compared with gamma-method; ii) the errors of proposed model predicting the bending stiffness for most BCC beams are within 10% of test results; however, nearly half of the predicted ones using gamma-method have errors exceeding 10% of test results, both of which verify that the mechanism and data mining-dual driven model receives a better prediction for short-term bending stiffness of BCC beams.

Influence of Static Pre-Loading on the Dynamic Bending Strength of Concrete with Particle Element Modeling

An experimental investigation of pre-loading effects on the dynamic behaviour of concrete

Bending Stiffness of Bamboo-Concrete Composite (BCC) Beams under Short-Term Loads

ANALYZING INFLUENCE OF NONPRESTRESSED REINFORCEMENT ON THE BEHAVIOR OF UNBONDED PRESTRESSED CONCRETE BEAMS

Simulations of concrete bending and rate effects based on meso-scaled particle elements

Influence of Flexural Loading on Chloride Ingress in Concrete Subjected to Cyclic Drying-Wetting Condition

Numerical study of dynamic behavior of concrete by meso-scale particle element modeling

Dynamic Strength of Concrete under Initial Static Load

Study of dynamic behavior of concrete under splitting tensile tests based on mesomechanics

Analysis of Ultimate Loading Capacity of the Prestressed Concrete Curved Bridge

Influence of Effective Prestress on Ultimate Bearing Capacity for Large-Span Prestressed Concrete Bridge

Rate effect of concrete strength under initial static loading

Research on Strength and Deformation Characteristics of Unbonded Prestressed Concrete Beams

Simulating analysis of cantilever casting of prestressed concrete bridge

Parametric Analysis on Compressive Strain Rate Effect of Concrete Using Mesoscale Modeling Approach

Effect of initial static load on the rate-sensitive behavior of concrete in compression

Bending resistance mechanism of prestressed ultra-high performance concrete - reinforced concrete beam based on a full-scale experiment

3D meso‐scale numerical model and dynamic mechanical behavior of reinforced concrete

Experimental Study on Dynamic Constitutive Model of Concrete under Impact Loading

Study on Dynamic Compressive Properties of Concrete with Different Loading Paths

Determining the Impact Behavior of Concrete Beams Through Experimental Testing and Meso-Scale Simulation: II. Particle Element Simulation and Comparison