Abstract:An SMA (shape memory alloy) is a functional material with a unique property known as the shape memory effect, or superelasticity. Microscopically, the mechanical actuation of this effect is based on reversible transformation between different crystal phases. To clarify the atomistic mechanism in SMA, we perform molecular dynamics simulation (MDS) of phase transformations for a Ni-Ti alloy, a typical alloy used for engineering SMAs. EAM potential, which can produce both B2 and B19' structures (stable crystal phases of Ni-Ti), is adopted to model the interatomic interaction of the nickel and titanium atomic systems. Two different-sized MDS models are constructed with unit cell structures of B2 phase. These structures are surrounded by free surfaces and constrained regions so as to be subjected to uniaxial tensile loading. A series of reversible processes likely to occur in SMA, including loading, unloading, heating, and cooling, is reproduced by corresponding stages of the MDS. Phase transformation is thought to be observable by detecting the local interatomic distances and bonding angles peculiar to B19' structure (martensite). During tensile loading simulations, the martensite crystal structure is always observed, having transformed from the B2 structure. At a large strain, models exhibit a rapid propagation of local lattice distortions accompanied by the formation of martensite. In unloading simulations, the larger model contains relatively less martensite than the smaller model. The discrepancy with regards to model size may depend on a different degree of constraint strength. Reverse transformation (from B19' to B2) occurs mainly in the subsequent heating stage, in which the stress is observed to increase under constant residual strain.

Homogeneous Shear-Driven Reversible Α-to-α″ Phase Transformation and Superelasticity of Titanium Investigated by Molecular Dynamics Simulations

Unexpected Dynamic Recrystallization Behavior of Ti-7Cu Alloy in Semi-Solid State

In-situ Investigation Via High Energy X-ray Diffraction of Stress-Induced(0002)α→(110)β Transformation in a Ti-5.5Mo-7.2Al-4.5Zr-2.6Sn-2.1Cr Alloy

Hot Deformation Behavior of a Novel Near-β Titanium Alloy Ti-5.5Mo-6V-7Cr-4Al-2Sn-1Fe in (α+β) Phase Region

Phase transformation mediated anomalous plasticity of titanium under severe loading conditions

Efficient phase-field simulation for linear superelastic NiTi alloys under temperature gradients

Deciphering the microstructural evolution and adiabatic shearing behavior of the titanium alloy with stress-induced ω phase transformation during dynamic compression

Superelasticity over a wide temperature range in metastable β-Ti shape memory alloys

Influence of stress-induced α’’ phase transformation on mechanical properties in metastable β type Ti-5Al-2.5Cr-5Mo-1Sn alloy

Observation of Phase Transformation and Structural Analysis for Ni-Ti Alloy by Molecular Dynamics Simulation

Atomistic simulation of martensite microstructural evolution during temperature driven $β\rightarrow α$ transition in pure titanium

Effect of High Strain Rate on Adiabatic Shearing of α+β Dual-Phase Ti Alloy

Stress-induced α′′ martensitic phase transformation and martensitic twinning in a metastable β titanium alloy

Molecular dynamics simulations of TC4 titanium alloy with mechanical property calculations after various heat treatments.

Tuning Thermal Expansion by a Continuing Atomic Rearrangement Mechanism in a Multifunctional Titanium Alloy

Phase Composition Effects on Dynamic Behavior and Strain Rate Sensitivity in Metastable β-Ti Alloys

Local Mechanical Response of Superelastic NiTi Shape-Memory Alloy Under Uniaxial Loading

Molecular dynamics calculations of stability and phase transformation of TiV alloy under uniaxial tensile test

Adiabatic shear instability in a titanium alloy: Extreme deformation-induced phase transformation, nanotwinning, and grain refinement

Effect of deformation and cooling on non-equilibrium microstructure evolution and phase-transition mechanism of Ti–6Al-2.5Mo-1.5Cr-0.5Fe-0.3Si

Orientation effect on / phase interface mediated deformation mechanism in titanium alloy