Abstract:Steel slag and phosphogypsum are industrial wastes produced during steelmaking and the wet phosphoric acid process, respectively, contributing to significant environmental challenges due to their low utilization rates. This study explores their combination with GBFS to develop a new ecofriendly cementitious material based on steel slag. The effects of initial factors on early properties were systematically investigated using an orthogonal test. Hydration and microstructural characteristics were obtained through analysis of hydration processes, product characteristics, microstructure, and pore structure, and hydration behaviors were postulated. The findings reveal that a lower steel slag-GBFS ratio leads to a higher strength of the composite system. A higher water-binder ratio leads to a longer setting time and greater fluidity. The composite exhibits a low exothermic reaction, characterized by three exothermic peaks on its hydration heat release curve. The primary hydration products are Ettringite and C-(A)-S–H gel. Gypsum acts as an intermediate product. The main reaction in the composite system is that bassanite first transforms into gypsum. Concurrently, the [SiO 4 ] 4− , and [AlO 4 ] 5− in steel slag and GBFS gradually depolymerize. Once the conversion of hemihydrate gypsum is completed, the gypsum begins to dissolve, forming the primary hydration products. As hydration progresses, the system gradually forms a structure where ettringite intertwines, with gel filling and encapsulating the ettringite. The composite exhibits a loose pore structure in the early stages, leading to lower mechanical performance. Strength increases rapidly from 3 to 7 d. In the later hydration stages, the volume of harmful pores increases again, which subsequently moderates the strength gain. Nevertheless, under optimal conditions, compressive strength reaches 34.1 MPa at 28 d.

Effects of Steel Slag Admixture with Ggbfs on Performances of Cement Paste and Mortar

Utilization of Steel Slag Powder As A Combined Admixture with Ground Granulated Blast-Furnace Slag in Cement Based Materials

Modification of steel slag powder by mineral admixture and chemical activators to utilize in cement-based materials

Effects of steel slag powder on workability and durability of concrete

Effect of blended steel slag–GBFS mineral admixture on hydration and strength of cement

Feasibility of Preparing Steel Slag–Ground Granulated Blast Furnace Slag Cementitious Materials: Synergistic Hydration, Fresh, and Hardened Properties

Hydration Superposition Effect and Mechanism of Steel Slag Powder and Granulated Blast Furnace Slag Powder

Effect of steel slag powder and stone powder by-product from manufactured sand on the mechanical properties and microstructure of cementitious materials

Preparation of steel slag-based cementitious materials compounded with GBFS and phosphogypsum: mix design, hydration, and microstructure characteristic

Resource utilization of solid waste from steel industries in cement-based cementitious materials: Mechanical properties, hydration behaviors, and environmental impact

Influence of thermally treated flue gas desulfurization (FGD) gypsum on performance of the slag powder concrete

Influence of Steel Slag on the Workability of Concrete

Compensation Effect of Converter Steel Slag Powder on the Shrinkage of Hardened Mortar Prepared by Ground Granulated Blast Furnace Slag and Portland Cement

Study on Effects of Steel Slag on Structure Formation of Hardened Cement Paste

Long-Term Properties of Concrete Containing Ground Granulated Blast Furnace Slag and Steel Slag

Preparing High Strength Cementitious Materials with High Proportion of Steel Slag Through Reverse Filling Approach

Effects of Steel Slag Powder as A Cementitious Material on Compressive Strength of Cement-Based Composite

The Influence of Steel Slag and Ferronickel Slag on the Properties of Alkali-Activated Slag Mortar

Steel Slag/Precarbonated Steel Slag as a Partial Substitute for Portland Cement: Effect on the Mechanical Properties and Microstructure of Stabilized Soils

Effect of Steel Slag and Granulated Blast-furnace Slag on the Mechanical Strength and Pore Structure of Cement Composites

Effects of a Combined Admixture of Slag Powder and Thermally Treated Flue Gas Desulphurization (FGD) Gypsum on the Compressive Strength and Durability of Concrete