Abstract:In laser-induced breakdown spectroscopy (LIBS), ablation takes place in general in an ambient gas of the atmospheric pressure, often in air but also in noble gas such as argon or helium. The use of noble gas is known to significantly improve the performance of the technique. We investigate in this work the morphology and the characteristics of induced plasma in argon and in air. The purpose is to understand the mechanism of the analytical performance improvement by the use of argon ambient with respective to air ambient and the dependence on the other experimental parameters such as the laser fluence. The observation of plasma morphology in different ambient gases provides also information for better design of the detection system which optimizes the signal collection according to the used ambient gases. More specifically, the expansion of the plasma induced on an aluminum target with nanosecond infrared (1064nm) laser pulse in two ambient gases, argon and the atmospheric air, has been studied with spectroscopic imaging at short delays and with emission spectroscopy at longer delays. With relatively low ablation laser fluence (65J/cm2), similar morphologies have been observed in argon and in air over the early stage of plasma expansion, while diagnostics at longer delay shows stronger emission, higher electron density and temperature for plasma induced in argon. With higher ablation laser fluence (160J/cm2) however, different expansion behaviors have been observed, with a stagnating aluminum vapor near the target surface in air while a propagating plume away from the target in argon. The craters left on the target surface show as well corresponding difference: in air, the crater is very shallow with a target surface chaotically affected by the laser pulse, indicating an effective re-deposition of the ablated material back to the crater; while in Ar a deeper crater is observed, indicating an efficient mass removal by laser ablation. At longer delays, a brighter, denser and hotter plasma is always observed in argon than in air as with lower ablation laser fluences. The observed different influences of the ambient gas on the plasma expansion behavior for different laser fluences are related to the different modes of laser-supported absorption waves, namely laser-supported combustion (LSC) wave and laser-supported detonation (LSD) wave.

Laser Ablation-Induced Spectral Plasma Characteristics in Optical Far- and Near Fields

Optical Near-Field Ablation-Induced Plasma Characteristics

Femtosecond Laser Ablation Induced Plasma Characteristics From Submicron Craters In Thin Metal Film

Experimental Study of Laser-Induced Plasma: Influence of Laser Fluence and Pulse Duration

Plasma Dynamics in Ultra-Short Laser Ablation in Electronic Materials

Features of plasma plume evolution and material removal efficiency during femtosecond laser ablation of nickel in high vacuum

Dynamics of the Plumes Produced by Ultrafast Laser Ablation of Metals

&Lt;title>ultrashort Laser Ablation of Metals</title>

Experimental study on the laser-matter-plume interaction and its effects on ablation characteristics during nanosecond pulsed laser scanning ablation process.

Convoluted Effect of Laser Fluence and Pulse Duration on the Property of a Nanosecond Laser-Induced Plasma into an Argon Ambient Gas at the Atmospheric Pressure

Ultraviolet Versus Infrared: Effects of Ablation Laser Wavelength on the Expansion of Laser-Induced Plasma into One-Atmosphere Argon Gas

Resonant laser ablation of metals detected by atomic emission in a microwave plasma and by inductively coupled plasma mass spectrometry.

Dynamics of Nanoscale Phase Decomposition in Laser Ablation

Femtosecond Laser Induced Ablation Dynamics Probing by Emission and Scattering Spectroscopy under Various Vacuum Conditions

Infrared Nanosecond Laser-Metal Ablation in Atmosphere: Initial Plasma During Laser Pulse and Further Expansion

Temporally and spectrally resolved analysis of a copper plasma plume produced by ultrafast laser ablation

Plasma Modeling for Ultrashort Pulse Laser Ablation of Dielectrics

Multi-spot ultrafast laser ablation at ambient pressure – A new window on coalescing shock wave interactions

Enhancing the Expansion of a Plasma Shockwave by Crater-Induced Laser Refocusing in Femtosecond Laser Ablation of Fused Silica

Femtosecond Laser Plasma Plume Characteristics in the Nanojoule Ablation Regime

Morphology and Characteristics of Laser-Induced Aluminum Plasma in Argon and in Air: A Comparative Study