Hard Magnetic Properties of Melt-Spun R(Fe,M)12 Nitrides (r=nd or Pr; M=Mo or V)

JB Yang,P Oleinek,KH Muller
DOI: https://doi.org/10.1063/1.373766
IF: 2.877
2000-01-01
Journal of Applied Physics
Abstract:The hard magnetic properties of nitrided melt-spun R(Fe,M)12 (R=Pr and Nd, M=V and Mo) ribbons have been investigated. Hard magnetic powders were prepared by vacuum annealing of ground ribbons in the temperature range from 700 to 950 °C and subsequent nitrogenation. For NdFe10.5Mo1.5Nx and PrFe10.5Mo1.5Nx powders, coercivities as high as 10.4 and 4.5 kOe at room temperature, respectively, were achieved by carefully controlling the nitrogenation process. The coercivity strongly depends on the preparation route, i.e., annealing temperature as well as nitrogenation temperature and time. By the detailed investigation of the influence of these conditions, the optimum process parameters were determined. The coercivity mechanism of melt-spun NdFe10.5Mo1.5Nx powders shows characteristics of a randomly oriented single domain particle system. Poor coercivities have been obtained for Nd(Fe,V)12 and Pr(Fe,V)12. In these cases as well as for not optimally nitrogenated Nd(Fe,Mo)12, the low coercivity of the nitrided powders is related to (i) too large grain sizes, (ii) the presence of α-Fe additional to the ThMn12-type phase, or (iii) a nonhomogeneous nitrogenation of the powder.
What problem does this paper attempt to address?