Abstract:Transition metal oxides, which have a perovskite structure, have received much attention in recent decades. This is because of the very suitable properties that can be used in various industries. One of the fields where the properties of Perovskites can and have already been applied is in the power industry. Experimental studies of the last few years have reliably demonstrated that, using simple modifications, perovskite oxides can be used in applications utilizing direct sunlight and photocatalytic applications. The original strontium titanate oxide SrTiO3 (abbreviated STO) is only able to use the UV component of incident radiation and is inactive in visible light, remaining transparent to visible light. The reason for this state is its wide band gap, which at room temperature has a value of 3.2 - 3.25 eV. Studies have shown that doping the structure of these oxides with transition metals (TM) can cause a shift in the valence and/or conduction band. This is because of the 3d dopant bands that create new energy levels in the mentioned band gap, effectively reducing it. One of the elements of the TM group is nickel. According to some studies, it is likely that the Ni ion occurs in the cubic structure of STO in the form of Ni2+ and substitutes the Ti4+ sites. In the case of using this dopant, the shift of the absorption edge of STO:Nix relative to NiO was found to be 1.1 eV. The present work investigates the differences in the structure of STO:Nix prepared by magnetron deposition method with different dopant amount settings. At the same time, the difference in structure was observed when prepared under vacuum with Ar working gas and when O2 was flowed through the deposition chamber. The premise of this experiment was to verify the formation of oxygen vacancies in the STO structure on which the photocatalytic phenomenon could occur.

Electron Paramagnetic Resonance Probed Oxygen Deficiency in SrTiO3 with Different Cap Layers

Bandgap Controlling of the Oxygen-Vacancy-Induced Two-Dimensional Electron Gas in SrTiO3

Origin of Oxygen Partial Pressure-Dependent Conductivity in SrTiO3

Self-consistent DFT+$U$+$V$ study of oxygen vacancies in SrTiO$_3$

Oxygen vacancies in SrTiO$_{3}$ thin films at finite temperatures: A first-principles study

Oxygen vacancy diffusion in bulk SrTiO3 from density functional theory calculations

Oxygen vacancy related defect dipoles in CaCu3Ti4O12: Detected by electron paramagnetic resonance spectroscopy

Dislocation-related Surface-Layer Effect in SrTiO3 Single Crystals

Magnetism and metal-insulator transition in oxygen deficient SrTiO$_3$

Effect of oxygen vacancy variation on the photo-assisted degradation and structural phase transition of oxygen defective Ba(Fe,Co)O3-x

Thermally Stimulated Relaxation and Behaviors of Oxygen Vacancies in SrTiO3 Single Crystals with (100), (110) and (111) Orientations

Crystallite size and microstrain in the structure of SrTiO3 formed by magnetron deposition with and without O2 flow through the deposition chambre

Oxygen vacancy related defect dipoles in CaCu 3 Ti 4 O 12 : Detected by electron paramagnetic resonance spectroscopy

Structure and ferromagnetic instability of the oxygen-deficient SrTiO$_3$ surface

Atomic-scale imaging of nanoengineered oxygen vacancy profiles in SrTiO3

Effect of Oxygen Content on Structural and Transport Properties in SrTiO3−x Thin Films

Characterization of oxygen vacancy defects in Ba1−xCaxTiO3 insulating ceramics using electron paramagnetic resonance technique

Electronic structure evolutions driven by oxygen vacancy in SrCoO3−x films

Effect of oxygen-ion implantation on the local electronic structures of strontium-titanate single crystals: An investigation using synchrotron-based x-ray diffraction and x-ray photoemission techniques

Some Unusual Behavior of Dielectric Properties of SrTiO3 Metal Organic Chemical Vapor Deposition Grown Thin Films

Effect of oxygen vacancy on the magnetic and electric properties in MnTiO 3 ceramics