Abstract:The low-temporal coherence light (LTCL) has gained extensive attention in the research of inertial confinement fusion due to its instantaneous broadband physical properties. Recent reports have demonstrated that the LTCL has significant suppression effects on laser plasma instability. However, the temporal spike structures of the LTCL will not only induce the amplification of the self-focusing effect, but also make its small-scale self-focusing characteristics and corresponding damage mechanism more complicated. Exploring the self-focusing characteristics of the LTCL would provide an important information for improving the output power of the LTCL. In this paper, we designed a more accurate test method for comparing the nonlinear self-focusing effect of different lasers, and compared the self-focusing effect of LTCL and single longitudinal mode (SLM) pulse. In the experiments, fused silica was tightly focused by a short focal length lens to avoid input surface damage. A spatially resolved test method was designed to measure the nonlinear I×L value (where I is the incident intensity, L is the distance from the head of filamentation damage to the input surface), which was accumulated from the input surface to the head of filamentation damage. The results show that the nonlinear I×L value obtained by the spatially resolved method was lower than that obtained by the traditional test method, since the energy loss caused by incident surface damage and backward Stimulated Brillouin Scattering (SBS) has been resolved. Furthermore, the nonlinear I×L values of the SLM pulse and the LTCL were also compared by the traditional test method and spatially resolved method. The test results show that, due to the temporal spike structure, the LTCL has a lower nonlinear I×L value than that of the SLM pulse. The SBS effect and the different damage characteristics of the input surface were also analyzed. The study provides a more accurate test method for better analysis of self-focusing effect of LTCL and laser pulses with different characteristics, and hence a reference for design of high-power device of the low-temporal coherence light.

Self-focusing threshold of partially coherent light in large mode area fibers

Supercontinuum Generation in Submicrometer Diameter Silica Fibers

Subwavelength Focusing by a Micro/nanofiber Array.

Stimulated Raman Scattering Threshold for Partially Coherent Light in Silica Fibers

Beam Characteristic Analysis of Scalar Diffraction from Weakly Guiding Optical Fiber

Simulation and analysis of nonlinear self-focusing phenomenon based on ray-tracing

Self-focusing: From transient to quasi-steady-state

Self-focusing and stimulated Brillouin scattering effect of low-temporal coherence light and corresponding damage characteristics in fused silica

Self-focusing: Experimental

Generation of a High-Quality Partially Coherent Dark Hollow Beam with a Multimode Fiber.

Investigation of low-temporal coherence light self-focusing effect by spatial resolved method

Numerical Simulation and Comparison of Nonlinear Self-Focusing Based on Iteration and Ray Tracing

High-power Continuous-Wave Optical Waveguiding in a Silica Micro/nanofibre.

High-power Optical Continuous-Wave Waveguiding in a Silica Micro/nanofiber

Self-focusing of a partially coherent beam with circular coherence

10-W-level CW waveguiding in an optical micro/nanofiber

Self-imaging of waveguides and its potential applications in coherent combining

Influence of Focusing Depth on the Microfabrication of Waveguides Inside Silica Glass by Femtosecond Laser Direct Writing

Multiple Foci and a Long Filament Observed with Focused Femtosecond Pulse Propagation in Fused Silica.

Phenomenological Model for Spectral Broadening of Incoherent Light in Fibers Via Self-Phase Modulation and Dispersion

High-resolution wavefront shaping with a photonic crystal fiber for multimode fiber imaging.