Abstract:DOAS (differential optical absorption spectroscopy) is an important gas measurement system based on the Lambert-Beer law especially for the trace gas measurement. The measurement key of DOAS is the calibration of the measurement limit. The traditional calibration method is using standard gas. But the concentration value of standard gas has a large measurement uncertainty which can be large than 10% at ppt. This uncertainty is large than the corresponding specification of instruments which are calibrated. So this traditional method is invalid. A new calibration method is given which is based on spectral optical density. The relationship between measurement limit and optical density can be established using Lambert-Beer law. The optical density as a physical quantity can be measured in 10(-6) or more precisely, so the corresponding measurement limit can also be calibrated in ppb or ppt. Firstly, the kinds of optical densities and the total optical density of the measurement system which be calibrated should be analyzed and calculated according to the optical structure (or optical design diagram) of the system. This step is the key of this method because the types of the standard optical densities which are necessary for the measurement of the standard optical density film on the optical density standard equipment. Meanwhile, the optical structure should be understood in order to achieve this calculation. The optical structure include the optical path, every optic cell specification, sphere aberration, astimigation distribution, etc. Secondly, the standard optical density film should be filled in the optical path of the measurement system and the corresponding optical density value is measured. Especially, the optical density film must be filled in the proper station which is confirmed at the step 1 when calculate the different type of the optical density. The error station would make large measurement error which would make large effect into the end data. Then the two above optical density can be compared and the difference of the two value can be considered as the measurement limit. This method is based on the optical measurement without the standard gas. The evaluation error sources only are the measurement error of optical density and the alignment error of the optical structure of the calibrated system. So the calibration of the measurement system can be achieved on small uncertainty, and the measurement limit can be more precise. This method is applied on an open path DOAS and the corresponding experiment data are given.

Spatial resolution of DOFS and its calibration methods

Spatial Resolution and Its Calibration Method for Brillouin Scattering Based Distributed Sensors

A Comparison of Different Methods to Estimate the Effective Spatial Resolution of FO-DTS Measurements Achieved during Sandbox Experiments

Long-distance OFDR with High Spatial Resolution based on Time Division Multiplexing

Distributed Optical Fiber Sensors Based on Optical Frequency Domain Reflectometry: A review

Calibration test researches on distributed optical fiber strain sensors

Study on calibration of distributed optical fiber sensors based on BOTDR

Sensing Fiber Selection for Point Displacement Measuring with Distributed Optic Fiber Sensor

Long-Range High Spatial Resolution Distributed Temperature and Strain Sensing Based on Optical Frequency-Domain Reflectometry

Distributed Optical Fiber Sensing Measurement Based on Time Offset

High-spatial-resolution OFDR with single interferometer using self-compensation method

The Calibration Research Of Doas Based On Spectral Optical Density

Advanced Fiber Optic Sensing for Cryogenic Simultaneous Temperature and Strain Measurement

High Spatial Resolution OFDR System based on Independent Component Analysis Algorithm for Long-range Distributed Strain Measurement

Improving Spatial Resolution in Fiber Raman Distributed Temperature Sensor by Using Deconvolution Algorithm

Investigation of a Signal Demodulation Method Based on Wavelet Transformation for OFDR to Enhance Its Distributed Sensing Performance

High-fidelity distributed fiber-optic acoustic sensor with fading noise suppressed and sub-meter spatial resolution

Distributed High Temperature Monitoring of SMF under Electrical Arc Discharges Based on OFDR

Synchronous calibration device and method for strain and temperature of distributed sensor fiber (cable)

A Guided Multi-objective Optimization Method for Attenuation Calibration in Distributed Fiber Sensing

Recent Progress in Distributed Fiber Optic Sensors