Abstract:Polymer 3D-printing has been commercialized rapidly during recent years, however, there remains a matter of improving the manufacturing speed. Screw extrusion has a strong potential to fasten the process through simultaneous operation of the filament production and the deposition. This paper develops a control algorithm for screw extrusion-based 3D printing of thermoplastic materials through an observer-based output feedback design. We consider the thermodynamic model describing the time evolution of the temperature profile of an extruded polymer by means of a partial differential equation (PDE) defined on the time-varying domain. The time evolution of the spatial domain is governed by an ordinary differential equation (ODE) that reflects the dynamics of the position of the phase change interface between polymer granules and molten polymer deposited as a molten filament. Steady-state profile of the distributed temperature along the extruder is obtained when the desired setpoint for the interface position is prescribed. To enhance the feasibility of our previous design, we develop a PDE observer to estimate the temperature profile via measured values of surface temperature and the interface position. An output feedback control law considering a cooling mechanism at the boundary inlet as an actuator is proposed. In extruders the control of raw material temperature is commonly achieved using preconditioners as part of the inlet feeding mechanism. For some given screw speeds that correspond to slow and fast operating modes, numerical simulations are conducted to prove the performance of the proposed controller. The convergence of the interface position to the desired setpoint is achieved under physically reasonable temperature profiles.

Well‐posedness and Exact Controllability of the Mass Balance Equations for an Extrusion Process

Feedback Stabilization for the Mass Balance Equations of an Extrusion Process

Feedback stabilization for the mass balance equations of a food extrusion process

Well-posedness of the extrusion model described by coupled hyperbolic systems with a free boundary

Optimal Bounded Control of Stochastically Excited MDOF Nonlinear Viscoelastic Systems

Exponential Stabilization of Unstable Diffusion-Reaction Pdes with Mixed Boundary Condition

Feedback Stabilization of a Food Extrusion Process Described by 1D PDEs Defined on Coupled Time-Varying Spatial Domains

Research on Constant Velocity Extruding Process Control for 36,000-Ton Vertical Extrusion Press

Optimal control of a linearized continuum model for re-entrant manufacturing production systems

Polymer Extrusion: from Control System Design to Product Quality

Feedback stabilization of forming processes

An Enhanced Temperature Control Approach to Simulate Profile Extrusion

Stabilization of Filament Production Rate for Screw Extrusion-Based Polymer 3D-Printing

Motion Control of Electro-Hydrostatic Actuators with Modeling and Compensation of Nonlinear Bulk Modulus

Mathematical Modeling of Extrusion Agglomeration

Consensus Control Design for 360 MN Extrusion Machine Producing Process

1 d Wave Equations Coupled via Viscoelastic Springs and Masses: Boundary Controllability of a Quasilinear and Exponential Stabilizability of a Linear Model

Polymer extrusion control system design

Continuous Dependence and Optimal Control of a Dynamic Elastic-Viscoplastic Contact Problem with Non-Monotone Boundary Conditions

Numerical modelling of the viscoelastic polymer melt flow in material extrusion additive manufacturing

Well-posedness and exponential equilibration of a volume-surface reaction-diffusion system with nonlinear boundary coupling