Abstract:Lotus-type porous copper was fabricated using a continuous casting method in pressurized hydrogen and nitrogen gas atmospheres. This study evaluates the effects of process parameters, such as the hydrogen ratio, total pressure, and transference velocity, on the resulting pore structure. A continuous casting process was developed to facilitate the mass production of lotus-type porous copper. To achieve the desired porosity and pore diameter for large-scale manufacturing, a systematic evaluation of the influence of each process parameter was conducted. Lotus-type porous copper was produced within a hydrogen ratio range of 25–50%, a transference velocity range of 30–90 mm∙min−1, and a total pressure range of 0.2–0.4 MPa. As a result, the porosity ranged from 36% to 55% and the pore size varied from 300 to 1500 μm, demonstrating a wide range of porosities and pore sizes. Through process optimization, it is possible to control the porosity and pore size. The hydrogen ratio and total pressure were found to primarily affect porosity, whereas the hydrogen ratio, transference velocity, and total pressure significantly influenced pore diameter. When considering these parameters together, porosity was most influenced by the hydrogen ratio, whereas the total pressure and transference velocity had a greater influence on pore diameter. Reducing the hydrogen ratio and increasing the transference velocity and total pressure reduced the pore diameter and porosity. This optimization of the continuous casting process enables the control of porosity and pore diameter, facilitating the production of lotus-type porous copper with the desired pore structures.

Microstructure, Capillary Performance and Gas Permeability of Biporous Copper Fabricated by Tape Casting

Porous copper with capillary performance and gas permeability prepared by two-step foaming method

Fabrication and capillary characterization of multi-scale micro-grooved wicks with sintered copper powder

Effect of Copper Content on the Microstructure and Properties of the Sintered Porous Aluminum Wick

Fabrication and Characterization of Porous Copper with Ultrahigh Porosity

Microstructure and Sound Absorption of Porous Copper Prepared by Resin Curing and Foaming Method

Experimental Study on Capillary Microflows in High Porosity Open-Cell Metal Foams

Enhanced capillary performance of nanostructures copper woven mesh wick for ultrathin heat pipes

BME-Assisted Fabrication of Porous Copper Films with Adjustable Porosity and Ligament Width for Microelectronic Interconnects

Biomimetic Copper Forest Structural Modification Enhances the Capillary Flow Characteristics of the Copper Mesh Wick

Fabrication of Lotus-Type Porous Micro-Channel Copper by Single-Mold Gasar Technique

Enhanced capillary pumping performance of flexible heat pipe device with multi cross-section ultra-thin wick

Enhancing Capillary Pressure of Porous Aluminum Wicks by Controlling Bi-Porous Structure Using Different-Sized NaCl Space Holders

Effect of structural characteristics on the natural convective heat transfer performance of copper foam

Fabrication and Thermal Performance of Copper Pillars Modified Micro Heat Pipe (MHP)

Development of Sintered Ni-Cu Wicks for Loop Heat Pipes

Microstructure and Properties of Porous Copper Foils with High Specific Surface Area Prepared by Electrodeposition

Capillary-driven evaporation of superhydrophilic copper foams with ultra-high porosity

Development of an Efficient and Controllable Nano-porous Copper with Good Wettability and Capillary Performance for Wicks of Vapor Chamber

Fabrication, Structure and Property of Copper Foam

Optimizing the Pore Structure of Lotus-Type Porous Copper Fabricated by Continuous Casting