Abstract:Experiments and simulations were conducted for bubble columns with diameter of 0.2m (180mm i.d.), 0.5m (476mm i.d.) and 0.8m (760mm i.d.) at high superficial gas velocities (0.12–0.62m·s−1) and high solid concentrations (0–30vol%). Radial profiles of time-averaged gas holdup, axial liquid velocity, and turbulent kinetic energy were measured by using in-house developed conductivity probes and Pavlov tubes. Effects of column diameter, superficial gas velocity, and solid concentration were investigated in a wide range of operating conditions. Experimental results indicated that the average gas holdup remarkably increases with superficial gas velocity, and the radial profiles of investigated flow properties become steeper at high superficial gas velocities. The axial liquid velocities significantly increase with the growth of the column size, whereas the gas holdup was slightly affected. The presence of solid in bubble columns would inhibit the breakage of bubbles, which results in an increase in bubble rise velocity and a decrease in gas holdup, but time-averaged axial liquid velocities remain almost the same as that of the hollow column. Furthermore, a 2-D axisymmetric k–ε model was used to simulate heterogeneous bubbly flow using commercial code FLUENT 6.2. The lateral lift force and the turbulent diffusion force were introduced for the determination of gas holdup profiles and the effects of solid concentration were considered as the variation of average bubble diameter in the model. Results predicted by the CFD simulation showed good agreement with experimental data.

An Experiment Investigation of Particle Collection Efficiency in A Fixed Valve Tray Washing Column

Experimental Investigation of Flow Development in Large-Scale Bubble Columns in the Churn-Turbulent Regime

Study on bubble size distribution and local gas holdup in bubble column

Studies on hydrodynamics of slurry turbulent bubble column(Ⅰ) Gas holdup and its radial distribution

Experimental and Numerical Investigations of Scale-Up Effects on the Hydrodynamics of Slurry Bubble Columns

Hydrodynamics in Bubble Columns with Pin-Fin Tube Internals

Experiment and Numerical Simulation of the Motion of Bubble Swarm in a Bubble Column

The Measurement of Local Gas Holdup under High Superficial Velocity in Bubble Column

The Particle Removing Characteristics in a Fixed Valve Tray Column

Theoretical and Experimental Investigation on the Characteristics of Fly‐ash Scrubbing in a Fixed Valve Tray Column

Experimental Measurement and Theoretical Analysis on Bubble Dynamic Behaviors in a Gas-Liquid Bubble Column

Experimental and Modeling Investigation of Liquid-Induced Agglomeration in a Gas–Solid Fluidized Bed with Liquid Spray

Study on the Gas-liquid Performance of the Compound Tray

Experimental Investigation of Bubble and Particle Motion Behaviors in A Gas-Solid Fluidized Bed with Side Wall Liquid Spray

Effect of Particles on Hydrodynamics and Mass Transfer in a Slurry Bubble Column: Correlation of Experimental Data

Improvement of Fixed Valve Trays

Study of effect factor on solid concentrations in slurry bubble column

A new gas-liquid mass transfer enhancement method for a multi-downcomer sieve tray: Bubble breakup by falling droplets

Experimental Study on Two Different Gas-Liquid Separators Under Different Flow Patterns

Scrubbing Performance of Fine Particulates in Fixed Valve Scrubbing Tower

Effects of internals on macroscopic fluid dynamics in a bubble column