Abstract:2D and 3D numerical simulations with two-fluid approach were conducted to investigate the gas-liquid flow dynamic behaviour in a rectangle bubble column. In the simulations, k-ε and RNG k-ε turbulent models, which account for the influence of the bubbles on liquid phase turbulence, were employed to study the effect of such models on predication of the dynamic behaviour of the bubble plume. In addition, the influence of different interfacial force closures such as drag, lift and added mass forces were also assessed. The simulation results indicated that for the 2D cases, the use of k-ε model could merely yield a steady flow pattern with one big liquid circulation, while the use of RNG k-ε model could produce a steady flow pattern, characterised by the appearance of three large vortices. However, all the 3D simulations have captured the plume meandering behaviour. The results showed that the value of the turbulence eddy viscosity predicted with 3D simulation was one order smaller than that with 2D simulation. Particularly, the meandering period of the bubble plume predicted by RNG k-ε model, was obviously smaller than that predicted using k-ε model in 3D simulations. The former gave the average turbulence eddy viscosity to be almost one third of that predicted by the latter. The assessment of the use of different interfacial force closures and their combinations showed that the lift force has a pronounced effect on the result of bubbly flow behaviour besides the drag force. It was found that the predicted meandering period was much greater than the experimental observations without the inclusion of the lift force, while the predicted period was consistent with the experimental result when the lift force was considered. Our simulations also revealed that the inclusion of the added mass force could notably improve the prediction results.

Evaluation of a Bubble-Structure Dependent Drag Model for the Simulation of Bubbling Fluidization with Geldart A Particles

Development and Validation of Filtered Drag Models for Fluidization of Low-Density Geldart A Particles

Novel Bubble–Emulsion Hydrodynamic Model for Gas–Solid Bubbling Fluidized Beds

CFD Simulation for Up Flow Jet-Loop Reactors by Use of Bi-Dispersed Bubble Model

Experiment and Numerical Simulation on Slug Fluidization of Geldart D Particles

Numerical Simulations of a Bubbling Fluidized Bed Reactor with an Energy Minimization Multiscale Bubble Based Model: Effect of the Mesoscale

Numerical Modelling of Bubbling Flow Dynamic Behaviour in a Bubble Column

Dynamic Modelling of Fluidisation in Gas-Solid Bubbling Fluidised Beds

Experimental Investigation of Bubble and Particle Motion Behaviors in A Gas-Solid Fluidized Bed with Side Wall Liquid Spray

Hydrodynamics in a jet bubbling reactor: Experimental research and mathematical modeling

Evolution and Fluidization Behaviors of Wet Agglomerates Based on Formation-Fragmentation Competition Mechanism

Stream-Wise Distribution of Skin-Friction Drag Reduction on A Flat Plate with Bubble Injection

Experimental And Numerical Study Of Bubble Drag Reduction On A Flat Plate

Two-Fluid Model Simulations of the National Energy Technology Laboratory Bubbling Fluidized Bed Challenge Problem

Experimental research and model development on interfacial drag in rectangle channel bubbly and slug flow

Numerical Investigation of Microbubble Drag Reduction on an Axisymmetric Body Based on Eulerian Multiphase Model

An Improved Computational Fluid Dynamics-Discrete Bubble Model for Multiphase Bubble Flow Simulation with a Wide Grid/bubble Size Ratio

Homogeneous drag models in gas–solid fluidization: Big data analytics and conventional correlation

Drag Force of Bubble Swarms and Numerical Simulations of a Bubble Column with a CFD-PBM Coupled Model

CFD-DEM simulation of polydisperse gas-solid flow of Geldart A particles in bubbling micro-fluidized beds

Comparative analysis on gas–solid drag models in MFIX-DEM simulations of bubbling fluidized bed