Abstract:This study attempts to clarify the correlation between the structural parameters of vortex finders (diameter ratio and insertion depth) and the strong turbulent flow field and performance of cyclone separators. To elucidate the effects due to the overflow pipe diameter, insertion depth, and Reynolds number on the tangential velocity index (n) and separation efficiency, 0.3D, 0.4D, 0.5D, 0.6D, and 0.7D (where D is the diameter of the cyclone separator’s cylindrical section) were selected as the vortex finder diameter and insertion depth, which were studied using three methods: computational fluid dynamics (CFD) software Fluent, experiments, and artificial neural network simulations. With Fluent, the Reynolds stress model (RSM) of turbulence was adopted to describe transport equations, and the discrete phase model (DPM) for two-phase flow was used to calculate the efficiency and separate particles at different inlet velocities. Experiments were conducted to measure the operational pressure drop and separation efficiency of the system; subsequently, the results were used to validate the CFD calculation results. Finally, a 5–5-1 three-layer artificial neural network was established based on 336 sets of data for values of n obtained from numerical simulations. In addition, a backpropagation (BP) artificial neural network model was employed to predict the correlation between the structural and operational parameters of the cyclone separator and n values. The obtained results indicate that the BP artificial neural network can accurately predict the distribution of n values within the flow field of the cyclone. Increasing the diameter of the vortex finder with the same inlet velocity can reduce the total pressure drop due to the cyclone, thereby reducing the kinetic energy loss and improving the separation efficiency of fine particles. Increasing the insertion depth of the vortex finder leads to an increase in the values of n. Considering the stability of the flow field structure and energy dissipation, an S/D value between 0.5 and 0.6 is preferred.

Performance Evaluation of a New Cyclone Separator – Part II Simulation Results

Performance Evaluation of a New Cyclone Separator – Part I Experimental Results

Experimental and Computational Analysis of a Cyclone Separator with a Novel Vortex Finder

Numerical Simulation Study on Performance of a Cyclone Separator with Build-in Swirling Blades

Numerical Simulation of the Flow Field and Performance of an Innovative Cyclone Separator with a Downward Discharge of Gases

Multi-objective optimization of a novel vortex finder for performance improvement of cyclone separator

Numerical Simulation of Gas Flow in A Square Cyclone Separator with Double Inlets

Numerical Simulation of Three-Dimension Flow Field in a New-Type Cyclone Separator with a Radial Inlet Structure

Study of the performance and flow field of a new spiral-roof cyclone separator

A study on gas flow in spiral inlet cyclone separator

Numerical study of gas-solid flow in a radial-inlet structure cyclone separator

Numerical Simulating the Gas-solid Flow in Square Cyclone With a Curved Inlet

Experimental investigation on separation characteristics of axial cyclone separator

The Effect of Cross-Shaped Vortex Finder on the Performance of Cyclone Separator

Vortex analysis in flow field of cyclone separator with single volute inlet

Numerical Simulation of Gas and Particle Flow in Cyclone Separators

Effect of Internally Mounted Helical Fins on the Separation Performance of a Cylindrical Gas-Solid Cyclone Separator

Simulation and experimental study of effect of vortex finder structural parameters on cyclone separator performance

Numerical simulation of the particle-wall collision strength and swirling effect on the performance of the axial flow cyclone separator

Performance Study of an Axial-flow Gas-Liquid Cyclone Separator Without Throttleer

Numerical Simulation of Gas-Phase Flow Field in an Axial Flow Type Gas-Liquid Cyclone Separator