Abstract:This paper describes a systematic study on exploring and understanding degradation mechanisms for long-term thermal stability of dye-sensitized solar cells (DSSCs). A 1080-hour thermal stability testing of DSSCs was conducted. Two different temperature conditions were selected to deeply explore the degradation mechanisms of DSSCs performance. One temperature condition is at 25 degrees C, the other is under a temperature cycle from -20 degrees C to 25 degrees C. DSSCs were sensitized by bis(tetrabutylammonium) cis-bis(thiocyanato) bis(2,2'-bipyridine-4-carboxylic acid, 4'-carboxylate)ruthenium(II) (N719). The cells maintained ca. 80% of its initial overall power conversion efficiency (eta) after 1080-hour aging. It is found that the decrease of. was ascribed to the decrease of short-circuit current density (J(SC)) while the open-circuit photovoltage and the fill factor increased with time; and the decrease rate of J(SC) for the cell under the temperature cycle from -20 degrees C to 25 degrees C was slower, compared with the cell at 25 degrees C. From the physical point of view, the reason for the drop in J(SC) was analyzed. Several possible degradation mechanisms, which are stability of the dye, aging of the photoelectrode film, change of the electrolyte components, and degradation of the counter electrode, were discussed systematically. Particularly, the long-term stability of N719 adsorbed on the TiO2 electrode permeated in the electrolyte was investigated by using UV-visible absorption spectrum and resonance Raman scattering. Density functional theory calculations were applied to illustrate the deterioration of N719 which caused the decrease of the light harvesting efficiency of photoelectrode and subsequently decreased J(SC). Moreover, high temperature will accelerate the deterioration. Additionally, the change of the electron transport/transfer between the interfaces in DSSCs, which was caused by aging of the photoelectrode film, change of the electrolyte components, and degradation of the counter electrode, was analyzed with electrochemical impedance spectroscopy (EIS). The analysis result of EIS shows that the change of the electron collection efficiency of photoelectrode with time was not large. As a conclusion, the long-term stability of N719 is found to be the main reason for DSSCs degradation.

Failure Mechanism for Flexible Dye-Sensitized Solar Cells under Repeated Outward Bending: Cracking and Spalling off of Nano-Porous Titanium Dioxide Film

Photovoltaic Performance Degradation and Recovery of the Flexible Dye-Sensitized Solar Cells by Bending and Relaxing

Unexpected Efficiency Enhancement of Flexible Dye-Sensitized Solar Cells by Repeated Outward Bending

Mechanical Stability Study on PEDOT:PSS-Based ITO-Free Flexible Perovskite Solar Cells

Behavioral study of flexible platinum counter electrodes under alternative bending conditions

Tensile stress-dependent fracture behavior and its influences on photovoltaic characteristics in flexible PbS/CdS thin-film solar cells

Experimental Study on Loading-Induced Power Generation Decline of Component-Level Flexible Solar Cells

Electron Transportation And Recombination In Tio(2) Film For Flexible Dye-Sensitized Solar Cell

Degradation Mechanisms Investigation for Long-Term Thermal Stability of Dye-Sensitized Solar Cells

Inhibited Crack Development by Compressive Strain in Perovskite Solar Cells with Improved Mechanical Stability

Room Temperature Cold Sprayed TiO2 Scattering Layer for High Performance and Bending Resistant Plastic-Based Dye-Sensitized Solar Cells

A Numerical Simulation and Impedance Study of the Electron Transport and Recombination in Binder-Free TiO2 Film for Flexible Dye-Sensitized Solar Cells

Layer conductance reduction and failure analysis due to bending for superflexible perovskite solar cells

Surface modulus reconstruction toward robust flexible perovskite solar cells

Bending Durable and Recyclable Mesostructured Perovskite Solar Cells Based on Superaligned ZnO Nanorod Electrode

Synergetic Acceleration on the Degradation of Flexible Perovskite Solar Cells under Light and Stress Cooperation

Effects of Thickness of TiO2 Graded Film on the Photovoltaic Performance for Flexible Dye Sensitized Solar Cells

Effects of Thickness of TiO_2 Graded Film on the Photovoltaic Performance for Flexible Dye-Sensitized Solar Cells

Substrate Diameter-Dependent Photovoltaic Performance of Flexible Fiber-Type Dye-Sensitized Solar Cells with TiO2 Nanoparticle/TiO2 Nanotube Array Photoanodes

Study on a stretchable, fiber-shaped, and TiO2 nanowire array-based dye-sensitized solar cell with electrochemical impedance spectroscopy method

Unraveling the Degradation Mechanisms of Perovskite Solar Cells under Mechanical Tensile Loads