Abstract:The autoignition resistance of a practical gasoline is best characterized by the Octane Index, OI, defined as RON-KS, where RON and MON are respectively, Research and Motor Octane Numbers, S is the sensitivity (RON-MON) and K is a constant depending on the pressure and temperature history of the fuel/air mixture in an engine. Experiments in knocking SI engines, HCCI engines and in premixed compression ignition (PCI) engines have shown that if two fuels of different composition have the same OI and experience the same pressure/temperature history, they will have the same autoignition phasing. A practical gasoline is a complex mixture of hydrocarbons and a simple surrogate is needed to describe its autoignition chemistry. A mixture of toluene and PRF (iso-octane + n-heptane), TPRF, can have the same RON and S as a target gasoline and so will have the same OI at any given K value and will be a very good surrogate for the gasoline.In this paper, a method to define the composition of a TPRF to match both RON and MON of a target gasoline is presented. The appropriate TPRF as a surrogate for a particular gasoline, which has been extensively tested in a knocking SI engine, is identified using this method. A chemical kinetic model is used to calculate ignition delays at different pressures and temperatures for this surrogate TPRF. From these data, a simple Arrhenius type equation with a pressure correction to predict ignition delays is identified. This equation is used to find the ignition delay as a function of crank angle and calculate the Livengood-Wu integral, I, for a number of individual knocking cycles covering a wide range of operating conditions using the gasoline in a single cylinder engine. Knock is predicted to occur at the crank angle when the integral, I, reaches unity. The crank angle at which knock is predicted to occur using the simple equation for ignition delay for the surrogate TPRF agrees very well with the experimentally observed value for the gasoline for all the cases considered. Finally, using the chemical kinetic model for TPRF, simple equations which can be used to estimate ignition delay are presented for a range of RON and sensitivity. Such equations can be used to predict when knock occurs during the cycle for these gasolines if the pressure and temperature development with crank angle is known.

A methodology to relate octane numbers of binary and ternary n-heptane, iso-octane and toluene mixtures with simulated ignition delay times

Relating the octane numbers of fuels to ignition delay times measured in an ignition quality tester (IQT)

Understanding the blending octane behaviour of unsaturated hydrocarbons: A case study of C4 molecules and comparison with toluene

Testing the Validity of a Mechanism Describing the Oxidation of Binary N-Heptane/toluene Mixtures at Engine Operating Conditions

Investigating Auto-Ignition Behavior of N-Heptane/iso-octane/ethanol Mixtures for Gasoline Surrogates Through Rapid Compression Machine Measurement and Chemical Kinetics Analysis

Mapping surrogate gasoline compositions into RON/MON space

Ignition Delay Times Measurement and Kinetic Modeling Studies of 1-Heptene, 2-Heptene and N-Heptane at Low to Intermediate Temperatures by Using a Rapid Compression Machine

An Alternative Method Based on Toluene/n-Heptane Surrogate Fuels for Rating the Anti-Knock Quality of Practical Gasolines

Measurements and Kinetic Study on the Ignition Delay Time of Dimethyl Carbonate/n-Heptane/oxygen/argon Mixtures

Numerical Study on the Ignition Process of N-Decane/Toluene Binary Fuel Blends

A Simple Method to Predict Knock Using Toluene, N-Heptane and Iso-Octane Blends (tprf) As Gasoline Surrogates

A Study on the Low-to-intermediate Temperature Ignition Delays of Long Chain Branched Paraffin: Iso-cetane

Autoignition quality of gasoline fuels in partially premixed combustion in diesel engines

Correlating research octane numbers of gasoline surrogates with high temperature oxidation characteristics

Ignition Delay Time Measurements and Kinetic Modeling for N-Dodecane and Methane Blends at Low-to-intermediate Temperature Conditions

Ignition delay time measurements of diesel and gasoline blends

Experimental and Kinetic Study on Ignition Delay Times of 2,5-Dmf/n-heptane Blends

Effects of Equivalence Ratio and Blending Ratio on the Ignition Delays of N-Pentane/hydrogen Mixtures under Engine Relevant Pressure

Experimental And Kinetic Studies On Ignition Delay Times Of Dimethyl Ether/N-Butane/O-2/Ar Mixtures

Shock-tube Study of the Autoignition of N-Heptane/toluene/air Mixtures at Intermediate Temperatures and High Pressures

Probing the Antagonistic Effect of Toluene As a Component in Surrogate Fuel Models at Low Temperatures and High Pressures. A Case Study of Toluene/dimethyl Ether Mixtures