A kinetic modeling study on the oxidation of five hexane isomers
K. Zhang,C. Banyon,J. Bugler,Henry J. Curran
2015-01-01
Abstract:Chemical kinetic models have been developed for the five hexane isomers (n-hexane, 2-methyl pentane, 3methyl pentane, 2,2-dimethyl butane and 2,3-dimethyl butane). The low-temperature reaction pathways have been refined by the addition of alternative isomerization reactions for hydroperoxyl-alkyl-peroxyl (Ȯ2QOOH) radicals. New reaction rate rules, mostly from recently reported high-level calculations, have been applied. The thermodynamic parameters were estimated using the group additivity method. To validate these models, experimental ignition delay times for the oxidation of stoichiometric fuel/air mixtures of the five hexane isomers were obtained in a rapid compression machine and in a high-pressure shock tube. The reactivity of n-hexane, 2methyl pentane, 3-methyl pentane and 2,2-dimethyl butane are well predicted by the models. Further work is needed for the 2,3-dimethyl butane sub mechanism. Corresponding author: henry.curran@nuigalway.ie Proceedings of the European Combustion Meeting 2015 Introduction The oxidation of hexanes are less studied [1–5] in comparison to heptanes, especially n-heptane, which is a primary reference fuel [6–12]. Moreover, studies focusing on the low temperature oxidation of hexanes are even more scarce [3, 5]. In 1996, Burcat et al. [1] studied the ignition delay time of n-hexane-oxygenargon mixtures in a shock tube over a temperature range of 1020–1725 K, at pressures of 1–7 atm. A mechanism with 386 elementary reactions was validated against the experimental results. Later in 2004, Zhukov et al. [4] studied the ignition delay time for n-hexane at much higher pressures of 13–220 atm over the temperature range of 822–1380 K. The kinetic model for n-heptane published by Curran et al. [7] was used to simulate the ignition delay times with satisfactory agreement. However, these studies focused on the high temperature conditions under which the more complex lowtemperature chemistry of n-hexane had no obvious effect. In 2014, Mevel et al. [3] performed an experimental study of n-hexane oxidation in a flow reactor at low temperatures. Therein, n-hexane was used as a single component surrogate for kerosene. The temperature range studied was 450–1000 K and the pressure was 100 kPa. The gas phase mixture composition was measured by both laser-based diagnostics and gas chromatography at the reactor outlet. However, the species measured were mainly reactants, C2–C5 olefins and major products such as H2O, CO and CO2. Although the model from Ramirez et al. [13] which was used to simulate n-decane and biofuel chemistry reproduced most of the trends in the experimental observations, more detailed information about the speciation, especially about the important intermediates such as alkyl peroxides and cyclic ethers are needed to provide more insight into the lowtemperature chemistry. However, detecting and quantifying these intermediates that are less stable is difficult. Wang and coworkers [5] performed an experimental study of the low-temperature oxidation of the five hexane isomers in a JSR reactor over a temperature range of 550–1000 K at 1 atm. Both gas chromatography and synchrotron vacuum ultraviolet photoionization mass spectrometry (SVUV-PIMS) were used to measure the concentrations of the species, with good agreement observed between the two methods. Cyclic ethers, which are important intermediates in the negative temperature coefficient (NTC) temperature regime, have been identified and quantified for all five isomers, providing valuable data for the validation of kinetic models over the NTC region. This work reports a modeling study of the oxidation of the five hexane isomers. Measurements of ignition delay times for stoichiometric fuel/air mixtures have been carried out in a rapid compression machine and in a high-pressure shock tube over a temperature range of approximately 626–1010 K at a pressure of 15 atm. These data, in addition to the aforementioned speciation data from Wang et al. is used to validate an updated hexane isomers oxidation mechanism. This mechanism is based on our previous work [14] as a part of our continuous effort in building the oxidation mechanisms for alkanes in a hierarchical way (normal, branched and highly branched alkanes). New reaction pathways for the low-temperature region have been adopted to provide alternative isomerization reactions for hydroperoxyl-alkyl-peroxyl radicals, leading to dihydroperoxyl-alkyl radicals, which have multiple product channels analogous to those of the hydroperoxyl-alkyl radicals. Experiment Rapid compression machine The rapid compression machine at NUIG, which has a twin opposed piston configuration, has been described in detail by Brett et al. [15] and Affleck et al. [16]. A description of the heating system can also be found in a previous work [17]. A pressure transducer (Kistler 601A) was used to measure the pressure