Abstract:Photothermal catalytic hydrogen production driven by the full spectrum of outdoor solar radiation, represents a highly promising and efficient approach for hydrogen generation. This method is widely anticipated by researchers due to its potential to enhance photon utilization efficiency at the reaction source. However, limited attention has been devoted to the variations in photothermal conversion performance of particle reaction suspensions caused by objective fluctuations of solar irradiation, especially when the morphology of the nanostructure changes, which is a crucial factor for practical applications in hydrogen production. Based on this bottleneck, we prepared the typical photo-responsive TiO 2 @Go composite with varied dimensions ( i.e. , nanosphere TiO 2 @Go, nanorod TiO 2 @Go, nanosheet TiO 2 @Go) as research models, and systematically investigated their thermal conversion and sensible heat conversion performance under different working conditions. The results showed that at low nanofluid concentration, nanosphere TiO 2 @Go and nanosheet TiO 2 @Go exhibit better sensible heat conversion. As the particle concentration increases, the sensible heat conversion efficiency of all nanofluids decreases. It can also be found that the latent heat conversion efficiency tends to increase with the increase of concentration, but the nanorod TiO 2 @Go show the opposite, which should be closely related to the uniformity of the particle size in different directions. In addition, for the sensible heat storage properties of nanofluids, smaller particle size and abundant porosity due to particles aggregation were found to be more beneficial for varied shapes. The underlying functional mechanisms were elucidated associated with the analysis of particle structures, interfacial properties, and optical characteristics. We contend that our research could provide valuable insights for the large-scale implementation of solar photothermal hydrogen production and a reasonable selection of photothermal material morphology for outdoor working conditions.

Heat Transfer Analysis of Solar-Thermal Dissociation of NiFe2O4 by Coupling MCRTM and FVM Method

Exergy Distribution Characteristics of Solar-Thermal Dissociation of NiFe 2 O 4 in a Solar Reactor

Heat Transfer Analysis of Solar-Driven High-Temperature Thermochemical Reactor Using NiFe-Aluminate RPCs

Application of CoFe2O4-NiO nanoparticle-coated foam-structured material in a high-flux solar thermochemical reactor

Photo-thermal Coupling Water Splitting over Fe-doped TiO2 with Various Nanostructures

Thermochemical CO2 reduction over NiFe2O4@alumina filled reactor heated by high-flux solar simulator

Application of CoFe 2 O 4 -Nio Nanoparticle-Coated Foam-Structured Material in a High-Flux Solar Thermochemical Reactor

Combined Heat and Mass Transfer Analysis of Solar Reactor Integrating Porous Reacting Media for Water and Carbon Dioxide Splitting

Analysis of H2 and CO Production Via Solar Thermochemical Reacting System of NiFe2O4 Redox Cycles Combined with CH4 Partial Oxidation

Numerical Analysis of Hydrogen Production Via Methane Steam Reforming in Porous Media Solar Thermochemical Reactor Using Concentrated Solar Irradiation As Heat Source

Thermochemical Performance Analysis of Solar Driven CO2 Methane Reforming

Thermal and Chemical Reaction Performance Analyses of Solar Thermochemical Volumetric Receiver/reactor with Nanofluid

Numerical and Experimental Analysis of Reactor Optimum Design and Solar Thermal-Chemical Energy Conversion for Multidisciplinary Applications

Solar-driven Thermochemical Redox Cycles of ZrO2 Supported NiFe2O4 for CO2 Reduction into Chemical Energy

Exergetic Evaluation of the Effect of Nanofluid Utilization for Performance Enhancement of a Solar Driven Hydrogen Production Plant

Thermal-chemical Reaction Characteristics of Ni/Al2O3 Catalytic Porous Material Filled Solar Reactor for Dry Reforming of Methane Process

Ti3C2Tx and copper sulfide composite nanofluid with hierarchical structure for sustainable and efficient solar light-thermal conversion

Stability and Photothermal Properties of Fe3O4-H2O Magnetic Nanofluids

Thermal Model of a Solar Thermochemical Reactor for Metal Oxide Reduction

Influence of particle morphology on solar thermal conversion performance and sensible heat storage capacity: A case study of TiO 2 @Go binary nanofluid

Radiative Heat Transfer and Thermal Characteristics of Fe-based Oxides Coated SiC and Alumina RPC Structures As Integrated Solar Thermochemical Reactor