Abstract:Differing with the scanning microelectrode techniques, which scan microelctrode closely to the interface of electrode/electrolyte and make electrochemical imaging in a lateral spatial resolution, the technique of microelectrode with a micron diameter is of very high timeresolution and ratio of signal/noise in electrochemical measurements. The microelectrode technique allows doublelayer capacitance and background current for a microelectrode to be drastically reduced due to the exposed area of a microelectrode is usually 6～8 orders of magnetite lower than that of a conventional electrode with largescale exposed area. Microelectrode was recently developed as a new powerful electrochemical technique and widely used in the studies of electrochemical kinetics, electrodeposition, electroanalysis and batteries. However, most of the microelectrodes was limited with the novel metals, such as Pt and Au, and only a little of work has reported on using microelectrode in corrosion research. In the present work, the microelectrode technique was developed to study the initiation and propagation of pitting corrosion of 18/8 stainless steel. The insight into the dissolution process of inclusion defects at the anodic potential of active dissolution and the dynamic behavior of growth and ceases for the micropitting during its development was attained. Microelectrode technique may offer a numbers of advantages for further recognizing the mechanism of pitting corrosion: to catch the fast and weak signal in an early stage of pitting initiation because of extreme low in both of doublelayer capacitance and background current for a microelectrode; to clarify the dependence of pitting nucleation on the inhomogenious defects; and to follow the propagation process for a simulated single pitting corrosion.

Pitting Kinetics of 304 Stainless Steel Using ESPI Detection Technique

The Electrochemical and Morphological Characteristics of Single Metastable Pit for 304 Stainless Steel under Potentiostatic Polarization

Use of the Potentiostatic Pulse Technique to Study and Influence Pitting Behavior of 317L Stainless Steel

Correlation Study on Pitting Corrosion by Scanning Electrochemical Probe and Polarization Curve Measurements

Microelectrode Studies on the Pitting Corrosion Process of Stainless Steel

Influence of Potentionstatic Pulse Technique on Pitting Behavior and Pitting Resistance of 317L Stainless Steel

An Electromechanical Impedance-Based Sensor for Monitoring the Pitting Corrosion of Steel: Simulation with Experimental Validation

Electrochemical Imaging For The Pitting Initiation Of 18/8 Stainless Steel

Integrated Scanning Electrochemical Probes Assisted by ECSTM for in Situ Imaging of the Pitting Corrosion Process of Carbon Steel in SCCP Solutions

Application of Potentiostatic Pulse Technique and Statistical Analysis in Evaluating Pitting Resistance of Aged 317L Stainless Steel

Effects of applied potential on stable pitting of 304 stainless steel

Pitting Corrosion of 304 L Stainless Steel Welds in Simulated Concrete Pore Solutions

Metastable pitting corrosion of 304 stainless steel in 3.5% NaCl solution

Acoustic emission behaviour during the evolution of a single pit on stainless steels

Studies on Pitting Corrosion in Austenitic Stainless Steel Interfered by Square‐wave Alternating Voltage with Different Parameters Using Multi‐potential Steps Method

INVESTIGATION OF THE PITTING CORROSION OF 18-8 STAINLESS STEEL IN EARLY STAGE I. BY USING THE SMRE TECHNIQUE

Electrochemical Characteristic on Iron-oxidizing Bacteria Inducing Pitting Corrosion of 316L Stainless Steel

Effect of Deformation‐induced Martensite on the Pit Propagation Behavior of 304 Stainless Steel

Pitting Corrosion Behavior of Stainless Steel in Ultrasonic Cell

Determination of Pitting Initiation of Duplex Stainless Steel Using Potentiostatic Pulse Technique

Pitting evolution of hyper duplex stainless steel 2707 at nose temperature by electrochemical tests and developed mixed potential model