Abstract:A new approach is presented in this paper to calculate the critical threshold value of fracture initiation. It is based on the experimental data for forming limit curves and fracture forming limit curves. The deformation path for finally a fractured material point is assumed as two-stage proportional loading: biaxial loading from the beginning to the onset of incipient necking, followed plane strain deformation within the incipient neck until the final fracture. The fracture threshold value is determined by analytical integration and validated by numerical simulation. Four phenomenological models for ductile fracture are selected in this study, i.e., Brozzo, McClintock, Rice-Tracey, and Oyane models. The threshold value for each model is obtained through best-fitting of experimental data. The results are compared with each other and test data. These fracture criteria are implemented in ABAQUS/EXPLICIT through user subroutine VUMAT to simulate the blanking process of advanced high-strength steels. The simulated fracture surfaces are examined to determine the initiation of ductile fracture during the process, and compared with experimental results for DP780 sheet steel blanking. The comparisons between FE simulated results coupled with different fracture models and experimental one show good agreements on punching edge quality. The study demonstrates that the proposed approach to calculate threshold values of fracture models is efficient and reliable. The results also suggest that the McClintock and Oyane fracture models are more accurate than the Rice-Tracey or Brozzo models in predicting load-stroke curves. However, the predicted blanking edge quality does not have appreciable differences.

Evaluation of Seven Ductile Fracture Criteria for Failure Prediction of AZ31 Sheet in Warm Forming

Simulation of Ductile Fracture in an Aluminum Alloy Using Various Criteria

Predicting Sheet Forming Limit of Aluminum Alloys for Cold and Warm Forming by Developing a Ductile Failure Criterion

Suitability of some ductile fracture criteria and yield criteria in forming limit prediction

A New Ductile Fracture Criterion and Its Application to the Prediction of Forming Limit in Deep Drawing

Experimental and numerical investigations into the ductile fracture during the forming of flat-rolled 5083-O aluminum alloy sheet

Deformation failure behavior and fracture model of twin-roll casting AZ31 alloy under multiaxial stress state

Evaluation of Fracture Limit in Automotive Aluminium Alloy Sheet Forming

Application of Drucker–Prager Plasticity to Predict Fracture in Rectangular Cup Drawing of AZ31 Alloy Sheet

Prediction of Fracture in Square-Cup Forming of Aluminium Alloy

A Ductile Fracture Criterion under Warm-Working Conditions Based on the Multiscale Model Combining Molecular Dynamics with Finite Element Methods

Prediction of Ductile Fracture for Al6016-T4 with a Ductile Fracture Criterion: Experiment and Simulation

A New Method to Calculate Threshold Values of Ductile Fracture Criteria for Advanced High-Strength Sheet Blanking

Fracture Prediction in Non-Isothermal Viscous Pressure Bulging of Aluminum Alloy Sheet Using Ductile Fracture Criterion

The Numerical Method for Predicting Failure in Single Point Incremental Forming Using a New Anisotropic Ductile Fracture Model

New Ductile Fracture Criterion for Prediction of Fracture Forming Limit Diagrams of Sheet Metals

Fracture prediction for metal sheet deformation under different stress states with uncoupled ductile fracture criteria

Forming Limit Analysis of Mg-2Zn-1.2Al-0.2Ca-0.2RE Alloy Sheet Using Ductile Fracture Models

Prediction of forming limit for sheet metals between equi-biaxial tension and uniaxial tension using a new ductile fracture criterion

Model for predicting ductile fracture of SA508-3 steel undergoing hot forming

NUMERICAL SIMULATION OF THE FRACTURE IN SHEET METAL STAMPING BASED ON DUCTILE CRITERION