Hull-less barley flour supplemented corn extrudates produced by conventional extrusion and CO 2 injection process

m tugrul masatcioglu,erkan yalcin,park jong hwan,gihyung ryu,sueda celik,hamit koksel
DOI: https://doi.org/10.1016/j.ifset.2014.06.003
IF: 7.104
2014-01-01
Innovative Food Science & Emerging Technologies
Abstract:The effects of feed moisture content (20, 25%), exit–die temperature (80, 130°C), and extrusion-cooking method (with/without CO2 injection) on β-glucan (BG) levels and physicochemical properties of hull-less barley flour (HBF) supplemented (15, 30, 45%) corn extrudates were investigated. The highest HBF supplementation level (45%) resulted in higher BG levels (2.87–3.28%) in all extrusion conditions. In general, increasing feed moisture content from 20 to 25% and exit–die temperature from 80 to 130°C resulted in small increases in enzyme resistant starch type-3 (RS3) levels. However, the investigated extrusion conditions did not form substantial amount of RS3 and the highest RS3 content was 540mg/100g. Lower feed moisture content and higher exit–die temperature resulted in higher water solubility (WS) and lower water-binding capacity (WBC) values. Cold-paste viscosity (CV) was observed in all extrudates. High WS and WBC values of extrudates and the existence of CV values in RVA curves indicated complete starch gelatinization.
What problem does this paper attempt to address?