Abstract:Clarifying the flow laws of shale gas under high temperature and high pressure is the prerequisite to accurately predicting the productivity of deep shale gas wells. In this paper, a self-diffusion flow model of flow field and temperature field coupling (referred to as self-diffusion flow and heat coupling model) was established based on the previously proposed self-diffusion flow model, while considering the influence of the temperature field change. Then, its calculation result was compared with that of the flow model based on Darcy's law and Knudsen diffusion (referred to as modified Darcy flow model). Based on the self-diffusion flow and heat coupling model, the self-diffusion flow behaviors of deep shale gas under the influence of temperature field change were analyzed, and the influence of bottomhole temperature on the degree of reserve recovery of deep shale gas was discussed. Finally, the self-diffusion flow and heat coupling model was applied to simulate the production of one shale-gas horizontal well in the Upper Ordovician Wufeng Formation–Lower Silurian Longmaxi Formation in the Changning Block of the Sichuan Basin. And the following research results were obtained. First, at the same parameters, the shale gas production calculated by the self-diffusion flow and heat coupling model is higher than the result calculated by the modified Darcy flow model. Second, when temperature field change is taken into consideration, the self–dviffusion coefficient profile presents a peak, the gas density profile presents a valley and the data points corresponding to the peak/valley move synchronously to the internal formation, which indicates that the self–diffusion coefficient influences the gas mass transfer rate, and the influence range of near well low temperature on gas self-diffusion increases continuously as the production continues. Third, when the bottomhole temperature is lower than the formation temperature, the self–diffusion coefficient of the gas near the well decreases and the gas is blocked near the well, which reduces the gas well production. Fourth, the production simulation result of the case well shows that the self-diffusion flow and heat coupling model can predict the production of deep shale gas more accurately if temperature field change is taken into consideration. In conclusion, the self-diffusion flow and heat coupling model established in this paper is of higher reliability and accuracy and can be used for productivity simulation and prediction of deep shale gas wells. The conclusion of this paper has certain guiding significance for deep shale gas production and gas well productivity prediction.

A Novel Method for Predicting Gas/Oil Flow Rate from Temperature Log Data

Estimation of Oil Reservoir Thermal Properties Through Temperature Log Data Using Inversion Method

A Novel Method For Predicting Spatial Distribution Of Thermal Properties And Oil Saturation Of Steam Injection Well From Temperature Logs

Prediction of multi-reservoir production for water injection well by using temperature logging data

An Interpretation Method for a Gas Production Profile Based on the Temperature and Pressure Behavior of Low-Permeability Gas Reservoirs

An improved thermal model for predicting wellbore temperature distribution in deep-water gas well

An Interpretation Method of Gas–Water Two-Phase Production Profile in High-Temperature and High-Pressure Vertical Wells Based on Drift-Flux Model

A Copula-Based Statistical Method of Estimating Production Profile from Temperature Measurement for Perforated Horizontal Wells

Self-diffusion Flow and Heat Coupling Model Applicable to the Production Simulation and Prediction of Deep Shale Gas Wells

Flow Rate Measurement of Production Profile Logging Using Thermal Method

Study on temperature distribution along wellbore of fracturing horizontal wells in oil reservoir

Transient prediction method for flow temperature at wellbore bottom

A Model Based on the Random Forest Algorithm That Predicts the Total Oil–Water Two-Phase Flow Rate in Horizontal Shale Oil Wells

Analysis for formation thermal properties of water injection well from temperature data

A New Method of Measuring the Oil–air–water Three-Phase Flow Rate

Numerical simulation of temperature and pressure distribution in producing gas well

Numerical Modelling Study of Oil–Gas–Water Three-phase Transient Bubbly Flow in HTHP Wells

Predicting the Distribution of Pressure, Temperature, Velocity, and Density of Transient Flow in HTHP Production Wells by the Finite Difference Method

Analysis for Flow and Heat Transfer of Thermal Recovery Well with Steam and Multiple Thermal Fluids Injection

Analytical Model for Rate Transient Analysis in Low-Permeability Volatile Oil Reservoirs

Gas-Flow-Rate Inversion Based on Experiments and Simulation of Flame Combustion Characteristics in a Drilling Blowout