Abstract:The green wave coordinated control model has evolved from the basic bandwidth maximization model to the multiweight approach to an asymmetrical multiband model and a general signal progression model with phase optimization to improve the operational efficiency of urban arterial roads and reduce driving delays and the amount of exhaust gas generated by vehicles queuing at intersections. However, most of the existing green wave models of arterial roads are based on a single phase pattern and little consider the optimization of the combination of multiple phase patterns. Initial queue clearing time is also considered at the green wave progression line in the time–space diagram, which leads to a waste of green light time. This study proposes a coordination control optimization method based on an asymmetrical multiband model with phase optimization to address the abovementioned problem. This model optimizes four aspects in the time–distance diagram: phase pattern selection, phase sequence, offset, and queue clearing time. Numerical experiments were conducted using the VISSIM micro traffic simulation tool for intersections along Kunlunshan South Road in Qingdao, and the effect of green wave coordination was evaluated using hierarchical analysis and compared with the signal-timing schemes generated by the four models: the multiweight approach, the improved multiweight approach, an asymmetrical multiband model, and a general signal progression model with phase optimization. The results show that an asymmetrical multiband model with phase optimization obtains a total bandwidth of 314 s in both directions. In the outbound direction, average number of stops, average travel speed, average travel time, and average delay time improve by 16%, 7.9%, 17.9%, and 15.6%, respectively. In the inbound direction, they improve by 43.7%, 16.1%, 40.7%, and 36%, respectively. Polluting gas emissions and fuel consumption improve by 17.9%. The applicability of the optimization method under different traffic flow conditions is analyzed, and results indicate a clear control effect when the traffic volume is moderate and the turning vehicles on the feeder roads are few. This work can provide a reference for the optimization of subsequent arterial signal coordination and also has indirect significance for environmental protection to a certain extent.

Signal Coordination Scheme Based on Traffic Emission

A Two-Way Arterial Signal Coordination Method with Queueing Process Considered

A Method for Signal Coordination in Large-Scale Urban Road Networks

A signal coordination algorithm for two adjacent intersections based on approximate dynamic programming

Proactive Coordination of Traffic Guidance and Signal Control for a Divergent Network

Signal coordination control for traffic bottleneck using OD data

Robust Signal Timing Optimization with Environmental Concerns

Signal Coordination Algorithm Considering Vehicle Platoon Movement Characteristics on Arterial Streets

A Semi-"Smart Predict, then Optimize" Method for Traffic Signal Control.

Investigating Emission Reduction Benefit From Intersection Signal Optimization

A Decentralized Model Predictive Traffic Signal Control Method with Fixed Phase Sequence for Urban Networks.

Study on Pedestrian Signal Cycle Optimization

Traffic Emission Control Based on Emission Pricing and Signal Timing

An Adaptive Traffic Signal Coordination Optimization Method Based on Vehicle-to-infrastructure Communication

Intersection Signal Timing Optimization: A Multi-Objective Evolutionary Algorithm

Arterial Coordination Control Optimization Based on AM–BAND–PBAND Model

A Multi-Objective Optimization Method for Single Intersection Signals Considering Low Emissions

Traffic Signal Optimization Based on Fuzzy Control and Differential Evolution Algorithm

Optimization Method Based on Emission Factors of Signal Control for Bus Priority

An Eco-Driving Strategy at Multiple Fixed-Time Signalized Intersections Considering Traffic Flow Effects