Abstract:This paper reports a systematic study of a turbulent jet issuing from a rectangular slot nozzle of high-aspect ratio, AR (≡w/h, where w and h are the long and short sides of the slot, respectively) tested with and without sidewalls. The solid sidewalls were flush with each of the slot’s short sides vertically and extend axially along the streamwise direction of the jet. Hot-wire measurements were conducted at a Reynolds number based on slot-width (h) and exit centerline velocity of Reh≈7000 (for AR=30 and 60) and at 10,000 (for AR=30) up to 160h downstream. All jets have a potential core in which the local centerline velocity is approximately constant, followed by a transition region and then a statistically two-dimensional (2-D) region where the centerline mean velocity, Uc∼x−1/2. The potential core of the jet without sidewalls is shorter than that with sidewalls. Near field power spectral analysis reveals that the primary vortex shedding rate is higher for the jet without sidewalls than the jet with sidewalls. The 2-D region of the jet with sidewalls is found to extend over a longer axial distance than that of the jet without sidewalls. It is also demonstrated that both the decay and spread rates of the jet within the 2-D region are lower for the case with sidewalls. Beyond the 2-D region, the jet without sidewalls enters into a far field transitional phase and then tends to behave statistically like an axisymmetric jet with Uc∼x−1. The centerline turbulence intensity of the jet with sidewalls becomes asymptotic closer to the nozzle exit than the jet without sidewalls. The skewness and flatness factors confirm further statistical differences between the jet with and without sidewalls.

Characterization of Turbulent Jets from High-Aspect-Ratio Rectangular Nozzles

An Investigation of the Influence of Nozzle Aspect Ratio on the Velocity Field of Turbulent Plane Jet

Comparison of turbulent jets issuing from rectangular nozzles with and without sidewalls

Statistical Properties of Turbulent Free Jets Issuing from Nine Differently-Shaped Nozzles

The Influence of Nozzle-Exit Geometric Profile on Statistical Properties of a Turbulent Plane Jet

On Turbulent Jets Issuing from Notched-Rectangular and Circular Orifice Plates

The influence of nozzle aspect ratio on plane jets

Effect of noncircular orifice plates on the near flow field of turbulent free jets

The Influence of Reynolds Number on a Plane Jet

On the Influence of Initial Conditions on a Turbulent Plane Jet: the Role of Nozzle Exit Area

Mixing Characteristics of Axisymmetric Free Jets from a Contoured Nozzle, an Orifice Plate and a Pipe

Experimental Study on the Flow Field Characteristics in the Mixing Region of Twin Jets

Analysis of a turbulent round jet based on direct numerical simulation data at large box and high Reynolds number

Turbulent Heat Transfer From a Slot Jet Impinging on a Flat Plate

Three-Dimensional Simulation of Turbulent Rectangular and Square Impinging Jet Flows

Multi-Component High Aspect Ratio Turbulent Jets Issuing from Non-Planar Nozzles

Numerical Simulation of Turbulence Modulation by Cylindrical Particles in Round Jet

Influence Of Jet Exit Conditions On The Passive Scaler Field Of An Axisymmetric Free Jet

High frame rate characterization of interaction between twin-nozzle jet in crossflow

Similarity scaling of the axisymmetric turbulent jet

Non-equilibrium turbulence scalings and self-similarity in turbulent planar jets