Determination of Cr in Water and Sediment of Haidian Creek by Cloud Point Extraction-Flame Atomic Absorption Spectrometry
Shanhu Hu,Yanshi Wang,Linqian Chen,Zheng Wang,Zhuang Tong,Qin Deng,Shengxu Luo
DOI: https://doi.org/10.5004/dwt.2020.25285
IF: 1.1
2020-01-01
Desalination and Water Treatment
Abstract:A new method using cloud point extraction-flame atomic absorption spectrometry was established by using ammonium pyrrolidine dithiocarbamate as a chelating agent and the cloud point phenomenon of a complexed anion-non-ionic surfactant mixture (Sodium dodecyl sulfate-Triton X-114 mixture). It was used for determining the morphology of chromium in the water and sediments of Haidian Creek. The experimental conditions inorganic electrolytes, pH of a solution, dosage of reagent, the temperature of a water bath, and heating time were optimized according to their effect on the determination of absorbance. The interference of common coexisting ions is discussed. The results show that under the optimized conditions, the standard curve for Cr(III) and Cr(VI) were both linear in the range of 0-9 x 10(-3)mu g/L. The detection limits for Cr(III) and Cr(VI) were 2.3 and 2.7 mu g/L, the correlation coefficients of the standard curve were 0.9904 and 0.9911, and the relative standard deviations were 3.7% and 4.5% (C = 0.04 mu g/mL, n = 11), respectively. Compared with the common coexisting ions, Fe3+ produced greater interference that cannot be neglected. A hybrid masking agent was prepared by mixing diethyltriaminepentaacetic acid and 30% triethanolamine solution at 1:25 ratio and then used in experiments. It could mask the interference of Fe3+ in the samples. The proposed method was successfully applied in the determination of chromium in water and sediment samples collected from Haidian Creek. It had recovery rates of 86%-98% and 90%-104% for Cr(VI) and Cr(III) respectively, and it gave satisfactory results.