Abstract:Most wearable intelligent biomedical sensors are battery-powered. The batteries are large and relatively heavy, adding to the volume of wearable sensors, especially when implanted. In addition, the batteries have limited capacity, requiring periodic charging, as well as a limited life, requiring potentially invasive replacement. This paper aims to design and implement a prototype energy harvesting technique based on wireless power transfer/magnetic resonator coupling (WPT/MRC) to overcome the battery power problem by supplying adequate power for a heart rate sensor. We optimized transfer power and efficiency at different distances between transmitter and receiver coils. The proposed MRC consists of three units: power, measurement, and monitoring. The power unit included transmitter and receiver coils. The measurement unit consisted of an Arduino Nano microcontroller, a heart rate sensor, and used the nRF24L01 wireless protocol. The experimental monitoring unit was supported by a laptop to monitor the heart rate measurement in real-time. Three coil topologies: spiral-spiral, spider-spider, and spiral-spider were implemented for testing. These topologies were examined to explore which would be the best for the application by providing the highest transfer power and efficiency. The spiral-spider topology achieved the highest transfer power and efficiency with 10 W at 87%, respectively over a 5 cm air gap between transmitter and receiver coils when a 200 Ω resistive load was considered. Whereas, the spider-spider topology accomplished 7 W and 93% transfer power and efficiency at the same airgap and resistive load. The proposed topologies were superior to previous studies in terms of transfer power, efficiency and distance.

Wireless Power Transmission System of Radio-Telemetry System for Physiological Parameters Detection

A study of the self-coupling magnetic resonance coupled wireless power transfer

An 8-Shaped Antenna-Based Battery-Free Neural-Recording System Featuring 3 Cm Reading Range and 140 Pj/bit Energy Efficiency

Implantable passive and wireless telemetering system based on SAW temperature sensor

A Current-Switching Communication Technique for Miniaturized Medical Implants

Design and Analysis of a Transcutaneous Telemetry Device for Brain Stimulator

Hybrid Coils-Based Wireless Power Transfer for Intelligent Sensors

Study of a Transcutaneous Wireless Communication System

A transcutaneous energy transmission system for artificial heart adapting to changing impedance.

Study on implantable low-power consumption wireless system for small animal monitoring

An efficient wireless power transmission system for the capsule endoscopy applicaton

A Linear-Power-Regulated Wireless Power Transfer Method for Decreasing the Heat Dissipation of Fully Implantable Microsystems

A Multi-Dimensional Analysis of a Novel Approach for Wireless Stimulation.

A Novel Design of Transcutaneous Power and Data Bidirectional Transfer System for Biomedical Implants

Omnidirectional Wireless Power Transfer for Millimetric Magnetoelectric Biomedical Implants

Electronic Design for an Implantable Wireless Power and Data Transmission System

A New Omnidirectional Wireless Power Transmission Solution for the Wireless Endoscopic Micro-Ball.

Preliminary Study on a Three-coil Wireless Power Transfer System for Endoscope Micro-robot of Intestinal Diagnosis: Design, Optimization and Validation

Wireless Power Transmission with Uniform Power Delivery in the 3D Space of the Human Body using Resonators in Parallel

A 27-Mbps, 0.08-mm3 CMOS Transceiver with Simultaneous Near-field Power Transmission and Data Telemetry for Implantable Systems

System of magnetic coupled PPM transcutaneous wireless communication