Abstract:Shell-and-tube heat exchangers are the most common type of heat exchangers in oil refineries and other large chemical processes. In this manuscript, we demonstrate that the shell-side flow in a cylindrical shell was not as homogeneous as that in a rectangular shell. According to the periodic flow field and the arrangement of tubes in the rectangular shell, the solid-fluid coupling heat transfer model consisting of a single tube section and the outer and inner fluids was developed to represent the whole heat exchanger. Using this model, the relationship among four temperatures, namely the inlet and outlet temperatures of tube-side fluid and the upstream and downstream temperatures of shell-side fluid, was established. By dividing each tube into several tube sections at the sites of baffles, a method for predicting the temperature field of the rectangular shell-and-tube heat exchanger was proposed. Based on the node temperature correlation, all the node temperatures were obtained by iterative computation using the established relationship between the four temperatures and the operating conditions. It was found that the temperature distribution of the fluid in tube was approximately linear along axial direction, but the temperature of tube showed nonlinear regularity. The axial deformation compatibility condition for the tube bundle and shell was considered when resolving the stresses in tubes. For the model established in this paper, the mean temperature of the tube at lower position was found to be larger than that at higher position; hence the thermal expansion of the tube at the lower end is larger. In the case the tube-side fluid was heated, all tubes were pulled because of the larger axial thermal expansion of shell, and the stress in the tube with higher temperature is smaller because of the smaller strain.

Numerical Method and Its Application to Coupled System with Chemical Reaction, Fluid Flow and Heat Transfer: A Case Study of Shell-and-Tube Reactor

Numerical Study on Hydrodynamics, Mixing and Heat Transfer of Highly Viscous Fluid in a Novel Shell-and-tube Heat Exchanger with X-type Baffles

CFD simulation of cross flow in multi-tubular fixed-bed reactor of industrial level

Numerical Simulation of the Heat Transfer Inside a Shell and Tube Heat Exchanger Considering Different Variations in the Geometric Parameters of the Design

Numerical Computations on Flow and Heat Transfer Characteristics of a Helically Coiled Heat Exchanger Using Different Turbulence Models

Numerical Simulation of Heat Transfer in Finned Tube of Heat Recovery Unit Using Fluid-Solid Coupled Method

Numerical study of heat transfer and pressure drop characteristics in helical tubes based on OpenFOAM

Investigation of Heat Transfer Rates on Shell and Tube Heat Exchanger by Numerical Modelling via CFD Analysis

Numerical Analysis of a Small Size Baffled Shell-and-Tube Heat Exchanger Using Different Nano-Fluids

Two parallel methods for the three-dimensional CFD coupling simulation of shell and tube heat exchangers

Development of a Transient Model for Evaluation of Shell and Tube Heat Exchanger with Helical Baffles Applied for SiO2 Nanofluid

Numerical analysis on the coolant-flow and heat-transfer in the fuel assembly

Numerical evaluation of the heat transfer in a shell and corrugated coil tube heat exchanger with three various water‐based nanofluids

Full Model Simulation of Shellside Thermal Augmentation of Small Heat Exchanger with Two Tube Passes

Simulation of Conjugate Heat Transfer in Thermal Processes with Open Source CFD

Study on coupled heat transfer model and enhanced heat transfer law of liquid metals and supercritical fluids

Temperature Field Prediction of Rectangular Shell-and-Tube Heat Exchanger

Numerical heat transfer to LBE flow in a wire-wrapped 19-rod bundle using an OpenFOAM-based solver: fourParameterFoam

The design of heterogeneous simulation reactor based on Fluent

Numerical Simulation and Sensitivity Analysis Using RSM on Natural Convective Heat Exchanger Containing Hybrid Nanofluids

Theoretical and numerical study of a shell and tube heat exchanger using 22% cut segmental baffle