Abstract:A portable laser sensor for trace ammonia (NH3) is developed based on near-infrared laser absorption spectroscopy. Tunable diode laser absorption spectroscopy in conjunction with wavelength modulation spectroscopy is implemented by a system-on-chip based on field-programmable gate array. A variable temperature multipass cell with a 15m optical path length is adopted to enhance the absorption path length and avoid the NH3 adsorption. The physical dimension of the sensor is minimized into 43 x 18 x 16 cm(3) on the benefit of home-made electronic system and compact optical design. A unique absorption line of NH3 around 1.51 sm covered by a distributed feedback diode laser is selected to reduce the influence from carbon dioxide, vapor and other trace gases. Calibration-free modulation spectroscopy is employed to avoid the random fluctuations due to laser noise and non-absorption transmission losses. The performance of sensor including adsorption of NH3, stability and flow of gas are examined and discussed in detail. For removing the adsorption of NH3, the temperature-dependent curve is obtained by the direct absorption spectroscopy, and it shows that the adsorption is significantly suppressed at (or higher than) 415 K. According to Allan deviation analysis, the minimum detection limit is 0.16 ppm at 184 s, and the rise time and the fall time of system are about 4.5 s and 3.7 s, respectively. The feasibility of the sensor is validated and deployed to monitor the NH3 slip in selective catalytic reduction (SCR) of coke oven flue gas. The work provides a potentially valuable control sensor for SCR.

Photoacoustic Spectroscopy Using a Quantum Cascade Laser for Analysis of Ammonia in Water Solutions

Photo-acoustic spectroscopy using a quantum cascade laser (QCL) for analysis of ammonia in water solutions

Quartz-Enhanced Photoacoustic Sensor Based on a Multi-Laser Source for In-Sequence Detection of NO2, SO2, and NH3

A Portable Sensor for In-Situ Measurement of Ammonia Based on Near-Infrared Laser Absorption Spectroscopy

Open-Path Laser Absorption Sensor for Mobile Measurements of Atmospheric Ammonia

Nitrous oxide quartz-enhanced photoacoustic detection employing a broadband distributed-feedback quantum cascade laser array

Multi-gas quartz-enhanced photoacoustic sensor for environmental monitoring exploiting a Vernier effect-based quantum cascade laser

A New Analytical Method to Quantify Ammonia in Freshwater with a Bulk Acoustic Wave Sensor

A Laser-Based Multipass Absorption Sensor for Sub-ppm Detection of Methane, Acetylene and Ammonia

A Dual-Gas Sensor Using Photoacoustic Spectroscopy Based on a Single Acoustic Resonator

Sub-ppb level HCN photoacoustic sensor employing dual-tube resonator enhanced clamp-type tuning fork and U-net neural network noise filter

Highly selective and sensitive detection of volatile organic compounds using long wavelength InAs-based quantum cascade lasers through quartz-enhanced photoacoustic spectroscopy

Development of Ammonia Gas Sensor Using Optimized Organometallic Reagent

Humidity enhanced N2O photoacoustic sensor with a 4.53 μm quantum cascade laser and Kalman filter

Ultra-Highly Sensitive Ammonia Detection Based on Light-Induced Thermoelastic Spectroscopy

Swept-wavelength mid-infrared fiber laser for real-time ammonia gas sensing

Quartz-enhanced photoacoustic NH3 sensor exploiting a large-prong-spacing quartz tuning fork and an optical fiber amplifier for biomedical applications

Colorimetric Derivatization of Ambient Ammonia (NH3) for Detection by Long-Path Absorption Photometry

Ultra-highly sensitive dual gases detection based on photoacoustic spectroscopy by exploiting a long-wave, high-power, wide-tunable, single-longitudinal-mode solid-state laser

In-water chemical sensing by fiber-optic evanescent waves spectroscopy using mid-infrared quantum cascade lasers

Additively Manufactured Detection Module with Integrated Tuning Fork for Enhanced Photo-Acoustic Spectroscopy