Stick–Slip Friction of Stainless Steel in Sodium Dodecyl Sulfate Aqueous Solution in the Boundary Lubrication Regime

Jun Zhang,Yonggang Meng
DOI: https://doi.org/10.1007/s11249-014-0431-z
2014-01-01
Abstract:The objective of this study is to correlate the mass and structure of the adsorbed sodium dodecyl sulfate (SDS) on stainless steel surface in aqueous solution with the boundary lubrication behavior, especially the stick–slip phenomenon of the ZrO2/stainless steel friction pair. Surface tension measurement, quartz crystal microbalance (QCM) technique and ball-on-flat friction test were performed in this study. The adsorption isotherm of SDS on stainless steel surface in SDS aqueous solution was measured by QCM, and four-stage adsorption behavior was found at the solid/liquid interface. As the SDS concentration increases, the mass of the adsorbed SDS molecules increases, while the structure of the adsorbed layer changes from monomers to hemimicelles. Tribological properties of ZrO2/stainless steel friction pair in SDS aqueous solution were verified with an UMT-3 tester. Boundary lubrication was emphasized as water-based lubrication easily fails in hydrodynamic lubrication due to its low viscosity. Stick–slip phenomenon was observed in the boundary lubrication of the adsorbed SDS film under certain loading and sliding conditions. Both the static and kinetic friction coefficients were analyzed with respect to the SDS concentration and sliding velocity. The stick–slip phenomenon is related to both of the adsorbed mass and adsorption structure of the SDS boundary film.
What problem does this paper attempt to address?