Abstract:We synthesized [PEA]3[Bi2I9] single crystals, and their crystal structure was analyzed. The spectroscopy data of the ground state and excited state show that the band gap is 2.048 eV. [PEA]3[Bi2I9] thin film has been proven to be an n‐type semiconductor and has good coverage on the ITO interdigital electrode. The ITO interdigital electrode can effectively confirm the photoelectric conversion properties of [PEA]3[Bi2I9] thin film. The photocurrent density‐time curves of the photodetector based on [PEA]3[Bi2I9] SC under different voltages (0.5, 1, 1.5, 2, and 2.5 V) at 386 nm with 30 W m−2 light intensity indicate the photocurrent density changes regularly with turning‐on/off of the light. These methods provide ideas for screening lead‐free optoelectronic material. Lead halide‐based salts exhibit good photoelectric properties; however, the use, leakage, and recovery of toxic lead require careful consideration. Therefore, developing a lead‐free optoelectronic material conveniently and quickly is very important. Moreover, there is relatively little research on the salts of bismuth halides. In this study, we synthesized [PEA]3[Bi2I9] single crystals (SC) by volatilizing N,N‐dimethylformamide (DMF) solvent at 70°C. The crystal system and spatial group of [PEA]3[Bi2I9] are monoclinic and P21/n, respectively. The Tauc plot reveals the optical band gap of the [PEA]3[Bi2I9] SC at 2.048 eV. The carrier mobility of [PEA]3[Bi2I9] SC is 47.4 cm2 V−1 s−1. Steady‐state fluorescence and time‐resolved fluorescence spectrum indicate that there are four fluorescence peaks and about 7 μs lifetime, respectively. The photodetector based on [PEA]3[Bi2I9] SC under different voltages (0.5, 1, 1.5, 2, and 2.5 V) exhibits stability and regularity with turning‐on/off of the light. In addition, thermogravimetric analysis (TGA) tests indicate that [PEA]3[Bi2I9] SC has considerable thermal stability at temperatures up to 260°C, showing promise for becoming a high temperature resistant and nontoxic sensor with good application prospects.

Single Crystal Formamidinium Lead Iodide (fapbi(3)): Insight into the Structural, Optical, and Electrical Properties

Perovskite Single Crystals and Thin Films for Optoelectronic Devices (conference Presentation)

Structural evolution, dielectric relaxation, and charge transport characteristics of formamidinium lead iodide (FAPbI3) perovskite

A Lead-Iodide Based Single Crystal Semiconductor: Exploring Multi-Orientation Photoconductive Behaviour Via Intervening Isopropyl Viologen Component Between The Inorganic [Pb2i6](N)(2-) Wires

Structural and excitonic properties of the polycrystalline FAPbI3thin films, and their photovoltaic responses

Pressure-Induced Polymorphic, Optical, and Electronic Transitions of Formamidinium Lead Iodide Perovskite

Nano-size nature of the $α$-FAPbI$_3$ by means of large-scale ab initio simulations

Fabrication of [001]‐Oriented FAPbI3‐Based Photodetector With Excellent Air Stability Via Green Anti‐Solvent Additive Engineering

Crystallization and stabilization of FAPbI3 single-phase perovskite

Unraveling exciton–phonon coupling in individual FAPbI3 nanocrystals emitting near-infrared single photons

Solution-Grown Formamidinium Hybrid Perovskite (fapbbr3) Single Crystals for Α-Particle and Γ-Ray Detection at Room Temperature

Solution-Grown Formamidinium Hybrid Perovskite (FAPbBr 3 ) Single Crystals for α-Particle and γ-Ray Detection at Room Temperature

Phase Transitions Of Formamidinium Lead Iodide Perovskite Under Pressure

Structural, electronic, and optical properties of cubic formamidinium lead iodide perovskite: a first-principles investigation

Spontaneous Low-Temperature Crystallization of Α-Fapbi3 for Highly Efficient Perovskite Solar Cells

Crystal structure, optical properties, mobility, and photoelectric performance of 3

N‐(2‐aminoethyl) Acetamide Additive Enables Phase‐Pure and Stable α‐FAPbI3 for Efficient Self‐Powered Photodetectors

Real-time observation of the buildup of polaron in α-FAPbI 3

Scalable Fabrication of High-Quality Crystalline and Stable FAPbI3 Thin Films by Combining Doctor-Blade Coating and the Cation Exchange Reaction.

Photoexcitation dynamics in solution-processed formamidinium lead iodide perovskite thin films for solar cell applications

Phase‐Transition‐Cycle‐Induced Recrystallization of FAPbI3 Film in An Open Environment Toward Excellent Photodetectors with High Reproducibility