Abstract:Increasing deployment of optical fiber networks and the need for reliable high bandwidth make the task of inspecting optical fiber connector end faces a crucial process that must not be neglected. Traditional end face inspections are usually performed by manual visual methods, which are low in efficiency and poor in precision for long-term industrial applications. More seriously, the inspection results cannot be quantified for subsequent analysis. Aiming at the characteristics of typical defects in the inspection process for optical fiber end faces, we propose a novel method, “difference of min-max ranking filtering” (DO2MR), for detection of region-based defects, e.g., dirt, oil, contamination, pits, and chips, and a special model, a “linear enhancement inspector” (LEI), for the detection of scratches. The DO2MR is a morphology method that intends to determine whether a pixel belongs to a defective region by comparing the difference of gray values of pixels in the neighborhood around the pixel. The LEI is also a morphology method that is designed to search for scratches at different orientations with a special linear detector. These two approaches can be easily integrated into optical inspection equipment for automatic quality verification. As far as we know, this is the first time that complete defect detection methods for optical fiber end faces are available in the literature. Experimental results demonstrate that the proposed DO2MR and LEI models yield good comprehensive performance with high precision and accepted recall rates, and the image-level detection accuracies reach 96.0 and 89.3%, respectively.

A vision based method for automated measurement of circular fiber cross-sections

Three measurement algorithms of PMF geometric parameters

Pattern Recognition Based on Enhanced Multifeature Parameters for Vibration Events in Φ‐otdr Distributed Optical Fiber Sensing System

A Novel Method for Diameter Measurement of Silicon Single Crystal

Research on Two Optical Methods for Aspheric Measurement

Measurement of the Characteristics of Pulp Fibers Based on Computer Vision

Fiber Diameter Measuring Method of Textile Materials Based on Phase Information

Animal Fiber Diameter Measuring Algorithm Using Image Recognition

Automatic Morphological Extraction of Fibers from SEM Images for Quality Control of Short Fiber-Reinforced Composites Manufacturing

A practical method for circular hole measurement based on machine vision

3D Measurement of Yarn Unevenness Based on A Low-Cost Multi-Camera Collaborative System and Signal Analysis

Identification of Structural Dynamic Characteristics Based on Machine Vision Technology

A Method for Measuring Parameters of Defective Ellipse Based on Vision

Binocular Vision-Based Yarn Orientation Measurement of Biaxial Weft-Knitted Composites

Animal Fiber Diameter Automatic Measurement Based on Image Recognition

Automated Inspection of Defects in Optical Fiber Connector End Face Using Novel Morphology Approaches

Fiber Optic Vibration Signal Recognition Based on IMFCC and CDET

High-resolution and large dynamic range fiber extrinsic Fabry–Perot sensing by multi-extrema-tracing technique

Semi-supervised Large-scale Fiber Detection in Material Images with Synthetic Data

A Novel Approach for Measurement of Free-Form Optical Elements with Digital Holographic Microscopy

A Novel Optical Fibre Process Tomography Structure for Industry Process Control