Abstract:Objective:Different electrical stimulation modalities have different biological effects.Many effective,mature treat-ment modalities have been developed so far.There are many electrical stimulation devices,which have only a specific treatment model,on the market.This project will develop an alternating electrical stimulation device with multiple treatment models to meet the needs of developing new therapeutic methods.Methods:The transcranial alternating electrical stimulator utilized MSP430F413 as a main controlled chip to control adjustable waveform generating circuit with MAX038 as a signal generating chip.Because The output frequency of MAX038 can be controlled over a frequency range of 0.1 Hz to 20 MHz,and it can produces triangle,sawtooth,sine,square,and pulse waveforms,could generate many kinds of stimulation modes.Through software programming,the device has a rich set of parameters and display.Results:It has nine Built-in common modes of treatment,and the parameters can be set quickly and easily by six interrupt buttons.With different electrodes,electrical stimulation modalities can be switched over:the conductive electrodes for current treatment,and the insulated electrodes for electric field treatment.Conclusions:Though many times commissioning and validation,the output voltage of alternating electrical stimulator Vp-p is 5 V.it can be enlarged by medical amplifier.the adjustable range of the output frequency was 0.1 Hz~5 MHz,the accuracy is ±2%,and might generate square wave,triangular wave,sine wave and their modulated wave with low noise.There is better stability and reliability,and it is satisfied with medical equipment safe standard IEC-601 promulgated by IEC.So it achieved the requirement.

Design of a Pulse-Triggered Four-Channel Functional Electrical Stimulator Using Complementary Current Source and Time Division Multiplexing Output Method.

Development of a Compact High-Voltage Functional Electrical Stimulation Device

A programmable multi-channel stimulator for array electrodes in transcutaneous electrical stimulation

Design and Testing of a Novel, Low-Cost, Low-Voltage, Functional Electrical Stimulator

Integrated Design of Functional Electrical Stimulator and Transcutaneous Electrical Nerve Stimulator on a Single Prototype

A 4-Channel Neural Stimulation IC Design with Charge Balancing and Multiple Current Output Modes

Design of Multi-Function Electrical Stimulator

A 4-Channel Neural Stimulation IC Design with Charge Balancing and Exponential Current Output

Design of Multipath Transcranial Alternating Electrical Stimulator

Design of a High Voltage Stimulator Chip for a Stroke Rehabilitation System.

Design and development of a low-cost biphasic charge-balanced functional electric stimulator and its clinical validation

A Wireless Wearable Surface Functional Electrical Stimulator

An Energy-Efficient High-Frequency Neuro-Stimulator with Parallel Pulse Generators, Staggered Output and Extended Average Current Range.

Design Of A Compact Wireless Multi-Channel High Area-Efficient Stimulator With Arbitrary Channel Configuration

Design of micro-stimulator based on FPGA

An Integrated Implantable Stimulator That is Fail-Safe Without Off-Chip Blocking-Capacitors

A custom-chip-based functional electrical stimulation system

Advanced Design and Implementation of a 2-Channel, Multi-Functional Therapeutic Electrical Stimulator

A Power-Efficient Current-Mode Neural/Muscular Stimulator Design For Peripheral Nerve Prosthesis

A Reconfigurable 16-Channel Hv Stimulator Asic For Spinal Cord Stimulation Systems

A High-Voltage Stimulation Chip for Wearable Stroke Rehabilitation Systems.