A Compact 19.7-to 43.8-Ghz Power Amplifier with 20.3-Dbm $p_{\mathrm{sat}}$ and 35.5% PAE in 28-Nm Bulk CMOS
Weisen Zeng,Li Gao,Ning-Zheng Sun,Hui-Yang Li,Xu,Hongtao Xu,Quan Xue,Xiuyin Zhang
DOI: https://doi.org/10.1109/jssc.2024.3364096
IF: 5.4
2024-01-01
IEEE Journal of Solid-State Circuits
Abstract:This article presents a broadband millimeter-wave (mm-wave) linear power amplifier (PA) to support 5G and beyond wireless communication. An asynchronously tuned coupled resonator (ATCR) circuit model is introduced to effectively design PA's non-ideal transformer-based broadband output matching network (OMN). Two adaptive feedback linearizers (AFLs) and multi-gated transistor (MGTR) techniques are adapted to optimize the linearity. Both amplitude-to-amplitude (AM-AM) and amplitude-to-phase modulation (AM-PM) distortion are improved over one octave with these techniques. A prototype PA is implemented in 28-nm bulk CMOS to verify the proposed ideas. The measured PA realizes 76% S-21- 3-dB fraction bandwidth (FBW) from 19.7 to 43.8 GHz, fully supporting five operating bands in 5G new radio (NR) frequency range 2 (FR2), i.e., n 257- n 261. The measured | AM-PM | is less than 4 degrees over 24-43 GHz. The large-signal measurement results show that the PA realizes 18.7-20.3-dBm P-sat , 16.8-19-dBm OP1dB, 24.9%-35.5% PAE(max), and 20.6%-29.7% PAE(P1dB) over 22-40 GHz. For 5G NR FR2 200-MHz 64-QAM signals [9.7-dB peak-to-average power ratio (PAPR)], the PA achieves an average Pout /PAE of 11.0 dBm/8.7% with -25.2-dB EVMrms at 24 GHz. The proposed PA achieves a compact size with a core area of 0.088 mm(2), making it very suitable for large-scale phased array beamformers.