Abstract:Large-diameter monopiles are the most commonly used foundation to support offshore wind turbines. Early designs usually adopted pile diameters (D) between 4 and 6 m, which is recently extended to 8 m and will target 10 m in the future. It is increasingly evident that the existing design method (i.e., API's p-y model) can significantly under-predict the lateral stiffness and capacity of large-diameter monopiles in soft clay, due to ignoring the soil resistances from base shear and base moment which become more pronounces as L/D reduces. In this study, a two-spring approach is proposed, aiming to predict the lateral behaviour of monopiles with varied L/D ratios in a unified manner. In light of the soil flow mechanisms around monopiles, the pure lateral soil resistance above the rotation point (RP) is quantified using a p-y model, while the resistances below the RP including the base shear and base moment are integrated into a moment-rotation spring (characterized by a M-R-theta(R) model) at the RP. It can naturally recover to a p-y model while analyzing flexible piles, where theta(R) = 0 at RP. Formulations of the 'p-y + M-R-theta(R)' model (including diameter-related p-y and M-R-theta(R) models, and the depth of the RP) are proposed based on the results of a series of well-calibrated 3D numerical models. The proposed model has satisfactorily reproduced a number of field and centrifuge test results on laterally loaded monopiles with a wide range of L/D ratios (including flexible, semi-rigid and rigid piles), using a unified set of parameters. Compared to the standard p-y model, the adoption of the proposed 'p-y + M-R-theta(R)' model is shown to substantially reduce design conservatism.

Effect of single and dual voids on vertical capacity of large-diameter monopiles in marine clay

Numerical Analysis of Monopile Behavior under Short-Term Cyclic Loading

A Numerical Study on the Lateral Loading Behaviour of Offshore Tetrapod Piled Jacket Foundations in Clay

Effect of Loading Rate on Lateral Pile-Soil Interaction in Sand Considering Partially Drained Condition

Centrifuge Modelling of Lateral Loading Behaviour of a “Semi-Rigid” Mono-pile in Soft Clay

Centrifuge Modeling of Monotonic and Cyclic Lateral Behavior of Monopiles in Sand

DETERMINATION ON CRITICAL DEPTH OF MONOPILE IN SAND UNDER CYCLIC HORIZONTAL LOAD

Lateral Cyclic Pile–soil Interaction Studies on a Rigid Model Monopile

Numerical modelling on effect of loading rate on uplift behavior of suction caissons

Model tests on characteristics of ocean and offshore elevated piles with large lateral deflection

Influence of Pile Diameter and Aspect Ratio on the Lateral Response of Monopiles in Sand with Different Relative Densities

Bearing capacity and deflection behaviors of large diameter monopile foundations in sand seabed

Influence of Vertical Shear Stresses Due to Pile-Soil Interaction on Lateral Dynamic Responses for Offshore Monopiles

Numerical Simulation of Offshore Monopiles with Reinforcement in Shallow Soil Layer

A Unified Lateral Soil Reaction Model for Monopiles in Soft Clay Considering Various Length-to-diameter (L/D) Ratios

Experimental study of the effects of the void located at the pile tip on the load capacity of rock-socketed piles

Lateral behavior of large-diameter monopiles in clay using transparent soil and centrifuge tests

Field and Numerical Study of the Lateral Response of Rigid Piles in Sand

Influence of Vacuum Preloading on Vertical Bearing Capacities of Piles Installed on Coastal Soft Soil

Quantifying the Influence of Pile Diameter on the Load Transfer Curves of Laterally Loaded Monopile in Sand

Upper-bound analysis of laterally loaded rigid monopiles in clay with linearly increasing strength