Abstract:Lithium–sulfur (Li–S) batteries are regarded as one of the most promising next-generation battery technologies owing to their ultrahigh energy density up to 2600 W h kg–1 and low cost. However, major challenges still remain in the application of Li–S batteries, such as shuttle effect and sluggish redox kinetics. Herein, it is demonstrated that phosphorus doping can not only significantly improve the polysulfide adsorption but also enhance the catalysis effects of metal–organic framework-derived CoS2 nanoboxes in Li–S batteries. Consequently, a modified separator integrated with P–CoS2 and carbon nanotubes effectively suppresses the polysulfide shuttle and propels the redox kinetics of polysulfides, thus promising higher specific discharge capacity, better rate, and stable cycle performance. Even under the high sulfur loading condition (4.8 mg cm–2), the areal discharge capacity of the cell with the functional separator can still remain at 4.5 mA h cm–2 after 100 cycles at 0.2 C. More importantly, this work may encourage more effort on anion doping for engineering the polar surface of transition-metal compounds to further mediate the interfacial redox chemistry between transition-metal compounds and polysulfides in Li–S batteries.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsami.1c00494?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsami.1c00494</a>.XRD patterns, SEM, TEM images of Co–MOF and CoS2; high-magnification XRD patterns of CoS2 and P-CoS2 in the 2θ range of 30–35°; EDS mapping images of CoS2 and P-CoS2; P 2p XPS spectrum of P-CoS2 after etching; SEM images from the front and the cross-section for the CNT-, CoS2/CNT-, and P-CoS2/CNT-modified separator; digital image of the P-CoS2/ separator and folding and unfolding test of the P-CoS2/ separator; permeation tests of the pristine Celgard, , CoS2/, and P-CoS2/ separators; CV curves of symmetric cells of CNTs with and without Li2S6 at 1 mV s–1; galvanostatic discharge/charge curves of P-CoS2/ at 2.0 C; galvanostatic discharge/charge curves and cycling performance of the P-CoS2 cathode without sulfur for the initial few cycles at 0.1 C; postmortem SEM images and EDS analysis of the lithium foil; postmortem SEM images and EDS analysis of CoS2 and P-CoS2 after 1.0 C cycles; and performance statistics of similar Li–S batteries in the literature (<a class="ext-link" href="/doi/suppl/10.1021/acsami.1c00494/suppl_file/am1c00494_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

The catalytic role of surface Co(PO3)2 on CoP for high-performance lithium-sulfur batteries

Oxidation States Regulation of Cobalt Active Sites through Crystal Surface Engineering for Enhanced Polysulfide Conversion in Lithium–Sulfur Batteries

Surface atomic modulation of CoP bifunctional catalyst for high performance Li-O2 battery enabled by high-index (2 1 1) facets

CoP@C with chemisorption-catalysis effect toward lithium polysulfides as multifunctional interlayer for high-performance lithium-sulfur batteries

Preparation of CoO-CoP-CNT heterogeneous materials for advanced lithium-sulfur battery cathode electrode

Phosphorization-Introduced Defect-Rich Phosphorus-Doped Co 3 O 4 with Propelling Adsorption–Catalysis Transformation of Polysulfide

Promoting polysulfide conversions via cobalt single-atom catalyst for fast and durable lithium-sulfur batteries

CoOx nanoparticles loaded on carbon spheres with synergistic effects for effective inhibition of shuttle effect in Li-S batteries

Crystalline-amorphous heterostructure on the phosphatized P-CoS 2 /CNT for augmenting the catalytic conversion kinetics of Li-S batteries

Efficient Catalysis of Ultrathin Two-Dimensional Fe2 O3 -CoP Heterostructure Nanosheets for Polysulfide Redox Reactions

Full Potential Catalysis of Co 0.4 Ni 1.6 P-V/CNT with Phosphorus Vacancies for Li 2 S 1-2 Deposition/Decomposition and S 8 /Li 2 S n (3 ≤ n ≤ 8) Conversion in Li-S Batteries

Highly active CoP-Co2N confined in nanocarbon enabling efficient electrocatalytic immobilizing-conversion of polysulfide targeting high-rate lithium-sulfur batteries

Efficient Catalysis of Ultrathin Two-Dimensional Fe2O3-CoP Heterostructure Nanosheets for Polysulfide Redox Reactions

Cooperative catalytic platinum species accelerating polysulfide redox reactions for Li-S batteries

Boosting the Rate Performance of Li-S Batteries Via Highly Dispersed Cobalt Nanoparticles Embedded into Nitrogen-Doped Hierarchical Porous Carbon

Integrating CoP/Co heterojunction into nitrogen-doped carbon polyhedrons as electrocatalysts to promote polysulfides conversion in lithium-sulfur batteries

Regulating Electrocatalytic Polysulfides Redox Kinetics through Manipulating Surface Electronic Structure of Molybdenum-Based Catalysts for High-Performance Lithium-Sulfur Batteries

Phosphorus-Doped Metal–Organic Framework-Derived CoS 2 Nanoboxes with Improved Adsorption-Catalysis Effect for Li–S Batteries

Oxygen-incorporated crystalline/amorphous heterophase cobalt vanadium selenide nanoplates with dense interfacial sites for robust lithium-sulfur batteries

Sulfur-doped hollow C@CoP nanosphere modified separator for enhancing polysulfides anchoring and conversion in Li–S batteries

Preparation and electrochemical performance of CoO-CoP-CNT functional membrane for Li S battery