Establishment and analysis of thoracicolumber three-dimensional finite element models in normal people and osteoporotic patients
Chu-jie Bai,Qi-rong Dong,Hou-shan Lü,Yi-jin Wang,Zhen-peng Guan,Feng Zhang,Tao Teng
DOI: https://doi.org/10.3321/j.issn:1673-8225.2006.41.048
2006-01-01
Abstract:Aim: To set up the three-dimensional(3D) finite element model of T 11-L 3 of osteoporotic patients on the basis of CT medical images, and analyze the biomechanical characteristics. Methods: The experiment was conducted at Institute of Biomechanics, Shanghai University from September 2003 to February 2004. One patient aged 65 years with osteoporosis was selected, whose bone density value compared with normal people, T value=-2.68<-2.5. The patient had no spinal deformity or demolish after CT scan. CT scan and graphics digital technique were used to obtain 3D coordinates of the thoracolumber spine, and the 3D finite element model was developed by using ANSYS5.0 finite element software and other tools. Results: The stress distribution of L 1 vertebral body under axial direction 800 N showed that the mean stress value of cortical bone, cancellated bone, end-flake, annular fibrosus and posterior structure of normal vertebra was higher than the osteoporotic vertebral body (1.786, 1.542 MPa; 0.742, 0.601 MPa; 0.839, 0.608 MPa; 0.862; 0.554 MPa; 0.424, 0.308 MPa). Observed from the cross section of vertebral body, the stress of outer cortical bone was greater compared with the inner bone. The stress of vertebral bone density focused on the nearly of lateral mass of vertebrae, while the stress of cancellated bone focused on the central part near the end-flake, the posterior structure distributed unevenly, which localized at lateral mass of vertebrae, isthmus and small joints and was low in processus transversus and spine. The stress distribution rules of thoracicolumber were similar to normal people. The stress distribution rules of osteoporotic vertebral body were similar to normal ones bearing the same weight, but lower than normal ones. The stress distribution had similar appearance, but the values were different. Conclusion: Using 3D finite element models method to analyze the mechanical trait of osteoporotic centrum is feasible, and can gain some unique information Moreover, the conclusions are credible.