Current Profile Dynamics and Core Magnetic Fluctuations in the MST Reversed-Field Pinch
D. L. Brower,W. X. Ding,S. D. Terry,J. K. Anderson,T. M. Biewer,B. E. Chapman,D. Craig,C. B. Forest,R. O'Connell,S. C. Prager,J. S. Sarff,J. C. Wright
2002-01-01
Abstract:RFP behavior, energy transport and dynamo effects, is determined in large part by magnetic fluctuations driven by the radial gradient in the parallel current density. It has long been considered that transport arises from stochasticity induced by overlapping magnetic islands, and that the current density profile is partly determined by the dynamo. Hence, measurement of magnetic fluctuations and the current density profile is essential to understanding the link between the current density distribution, fluctuations, and transport. Magnetic probes have been used to measure the edge current and magnetic field fluctuations, as well as the internal radial profiles in smaller, colder RFP plasmas. To date, however, direct non-perturbing measurement of the current density distribution and magnetic fluctuations in the core of a high-temperature RFP has been lacking. Recently, the internal magnetic field structure and core magnetic field fluctuations have been measured in a high-temperature RFP plasma using a newly developed fast-polarimetry system. The non-perturbing Faraday rotation measurement has up to 1 ∝sec time response and ~ 1 mrad phase resolution. MST polarimetry data for a standard sawtoothing discharge with Ip=400 kA is shown in Fig. 1. Each chord shows distinct sawtooth cycles, corresponding to the slow changes in the equilibrium (axisymmetric) magnetic field. With the time axis expanded to isolate an individual sawtooth crash (t=25 ms), the typical crash or relaxation time scale is measured to be 100-200 µs. A clear coherent oscillation is observed on all chords prior to the sawtooth crash. The frequency (~12 kHz) of these fluctuations matches the dominant m=1 tearing mode in MST (as measured by external magnetic coils). Finite coherence is observed for frequencies up to 100 kHz between polarimeter chords and an external magnetic sensor, indicating that the measured fluctuations are associated with magnetic activity. Since the measured Faraday rotation angle ( ) depends on both the density and magnetic field, = cn B d z Fz , it is necessary to separate the two in order to isolate the fluctuating magnetic field. The fluctuating portion of the Faraday signal can be written as