Abstract:The magnetic resonance sounding (MRS) technique is a non-invasive geophysical method that can provide unique insights into the hydrological properties of groundwater. The Cu coil sensor is the preferred choice for detecting the weak MRS signal because of its high sensitivity, low fabrication complexity and low cost. The tuned configuration was traditionally used for the MRS coil sensor design because of its high sensitivity and narrowband filtering. However, its narrow bandwidth may distort the MRS signals. To address this issue, a non-tuned design exhibiting a broad bandwidth has emerged recently, however, the sensitivity decreases as the bandwidth increases. Moreover, the effect of the MRS applications is often seriously influenced by power harmonic noises in the developed areas, especially low-frequency harmonics, resulting in saturation of the coil sensor, regardless of the tuned or non-tuned configuration. To solve the two aforementioned problems, we propose a matching network consisting of an LC broadband filter in parallel with a matching capacitor and provide a design for a coil sensor with a matching network (CSMN). The theoretical parameter calculations and the equivalent schematic of the CSMN with noise sources are investigated, and the sensitivity of the CSMN is evaluated by the Allan variance and the signal-to-noise ratio (SNR). Correspondingly, we constructed the CSMN with a 3 dB bandwidth, passband gain, normalized equivalent input noise and sensitivity (detection limit) of 1030 Hz, 4.6 dB, 1.78 nV/(Hz)1/2 @ 2 kHz and 3 nV, respectively. Experimental tests in the laboratory show that the CSMN can not only improve the sensitivity, but also inhibit the signal distortion by suppressing power harmonic noises in the strong electromagnetic interference environment. Finally, a field experiment is performed with the CSMN to show a valid measurement of the signals of an MRS instrument system.

High-sensitivity Cooled Coil System for Nuclear Magnetic Resonance in Khz Range.

A Broadband NMR Magnetometer System with Field Searching and Automatic Tuning Function

Low Field NMR System Based on High T_c DC-SQUID

Array high-sensitivity room temperature coil system for SNMR detection in shallow depth

Development Of A Rigid One-Meter-Side And Cooled Coil Sensor At 77 K For Magnetic Resonance Sounding To Detect Subsurface Water Sources

The Step-Edge Type HTS Rf SQUID Coupling with a LC Circuit in Ultra-Low Field NMR System

High-Tc Superconductor Detection Coils for a Magnetic Resonance System

A Cryogenically-Cooled High-Sensitivity Nuclear Quadrupole Resonance Spectrometer

Cryogenic receive coil and low noise preamplifier for MRI at 0.01T

Study on Signal Intensity of Low Field Nuclear Magnetic Resonance Via an Indirect Coupling Measurement

Low noise SQUID readout for detection of small magnetic field signal

Superconducting Quantum Interference Device and Its Application in Low-Field Nuclear M agnetic Resonance & Imaging

Low-field NMR Micro Coils Based on Printed Circuit Board Technology

A Cryogenic Tune and Match Circuit for Magnetic Resonance Microscopy at 15.2T

A Superconducting Quantum Interference Device Measurement System for Ultra Low-Field Nuclear Magnetic Resonance

High Magnetic Field Superconducting Magnet with Zero Helium Boil-Off for Nuclear Magnetic Resonance Spectrometer

High Magnetic Field Superconducting Magnet for 400 MHz Nuclear Magnetic Resonance Spectrometer

A liquid nitrogen cooled superconducting transition edge sensor with ultra-high responsivity and GHz operation speeds

TAPE HIGH-TEMPERATURE SUPERCONDUCTING RF COILS FOR MRI

Ultra-low field magnetic resonance imaging based on high Tc dc-SQUID

Design of a Matching Network for a High-Sensitivity Broadband Magnetic Resonance Sounding Coil Sensor