Abstract:We are investigating the feasibility of a high resolution positron emission tomography (PET) insert device based on the CdZnTe detector with 350 mu m anode pixel pitch to be integrated into a conventional animal PET scanner to improve its image resolution. In this paper, we have used a simplified version of the multi pixel CdZnTe planar detector, 5 mm thick with 9 anode pixels only. This simplified 9 anode pixel structure makes it possible to carry out experiments without a complete application-specific integrated circuits readout system that is still under development. Special attention was paid to the double pixel (or charge sharing) detections. The following characteristics were obtained in experiment: energy resolution full-width-at-half-maximum (FWHM) is 7% for single pixel and 9% for double pixel photoelectric detections of 511 keV gammas; timing resolution (FWHM) from the anode signals is 30 ns for single pixel and 35 ns for double pixel detections (for photoelectric interactions only the corresponding values are 20 and 25 ns); position resolution is 350 mu m in x,y-plane and similar to 0.4 mm in depth-of-interaction. The experimental measurements were accompanied by Monte Carlo (MC) simulations to find a limitation imposed by spatial charge distribution. Results from MC simulations suggest the limitation of the intrinsic spatial resolution of the CdZnTe detector for 511 keV photoelectric interactions is 170 mu m. The interpixel interpolation cannot recover the resolution beyond the limit mentioned above for photoelectric interactions. However, it is possible to achieve higher spatial resolution using interpolation for Compton scattered events. Energy and timing resolution of the proposed 350 mu m anode pixel pitch detector is no better than 0.6% FWHM at 511 keV, and 2 ns FWHM, respectively. These MC results should be used as a guide to understand the performance limits of the pixelated CdZnTe detector due to the underlying detection processes, with the understanding of the inherent limitations of MC methods.

Design and Study of a Coplanar Grid Array CdZnTe Detector for Improved Spatial Resolution.

Investigation of a CPG-array CdZnTe Γ-Ray Imaging Detector with Single Collecting Electrodes Readout

3-D Spatial Resolution of 350 $\mu$m Pitch Pixelated CdZnTe Detectors for Imaging Applications

Study of 2×2 Pixellated Nuclear Radiation Detector Based on CdZnTe

A Study on the CdZnTe Array Detector

Experiment and Simulation of Performance Characteristics for Pixellated CdZnTe Detectors with Various Thickness

Investigation of Room Temperature Nuclear Radiation CdZnTe Pixel Array Detector

Progress in the Development of CdZnTe Unipolar Detectors for Different Anode Geometries and Data Corrections

Improving the Spatial Resolution in CZT Detectors Using Charge Sharing Effect and Transient Signal Analysis: Simulation Study

Research on the Technological Progress of CZT Array Detectors

Design of digital nuclear signal processing system for CdZnTe detector

PERFORMANCE IMPROVEMENT OF CZT DETECTORS BY LINE ELECTRODE GEOMETRY

Development of 4×4 Pixel CdZnTe Detector

A study on the low energy X/γ-ray spectral response of CdZnTe planar detectors

Thick Pixelated CZT Detectors With Isolated Steering Grids

The Analysis of X-Ray Response of Cdznte Detectors

Fabrication and Characterization of Room Temperature Nuclear Radiation CdZnTe 3&#x000d7;3 Pixel Array Detector

Investigation of the limitations of the highly pixilated CdZnTe detector for PET applications.

Study on the Spectrum Improvement of a Capacitive Frisch Grid Structure for CdZnTe Detector

Stduy on Induced Signal Compensation and Filtering Methods and Spatial Resolution Ability of Pixel-Type CdZnTe Compton Imaging System

Study of Highly Pixelated CdZnTe Detector for PET Applications