Abstract:Laser-induced breakdown spectroscopy (LIBS) is an ideal real-time on-line method for the detection of minor elements in alloys. However, in the case of high-density plasma generated by LIBS, the self-absorption is usually an undesired effect because it not only reduces the true line intensity, introduces nonlinear effects in the growth of line intensity versus the content of the emitting species, but also affects the characterization parameters of the plasma, and finally affects the accuracy of quantitative analysis. Since the plasma electron temperature ( T ), radiation particle number density and absorption path length ( Nl ) determine the degree of self-absorption and affect the corrected spectral line intensity, a new self-absorption correction method based on temperature iteration is proposed. This method obtains the initial T through spectral line intensity, and calculates the self-absorption coefficient SA based on the initial Nl parameter to correct the spectral line intensity. Then a new T is obtained from the new spectral line intensity and the new SA is calculated to further correct the spectral line intensity. Through continuous calculation and correction of these two parameters, self-absorption correction is finally achieved. The experimental results of alloy steel samples showed that the linearity of Boltzmann plots was increased from 0.867 without self-absorption correction to 0.974 with self-absorption correction, and the linear correlation coefficient R 2 of the single variable calibration curve for Mn element increased from 0.971 to 0.997. The relative error of elemental content measurement has significantly improved from 4.32% without self-absorption correction to 1.23% with self-absorption correction. Compared with the commonly applied self-absorption correction methods, this method has obvious advantages of simpler programming, higher computation efficiency, and its independency of the availability or accuracy of Stark broadening coefficients. Moreover, this method can directly obtain the radiation particle number density and absorption path length, which is beneficial to the diagnosis and quantitative analysis of plasma.

Temperature Measurement of Laser-Induced Plasmas from the Intensity Ratio of Two Lines Emitted from Different Elements with the Same Ionization Degree.

Temperature Measurement with Compositional Correction of Gas Mixture Based on Laser-Induced Plasma

Comparison of excitation temperature of a laser-produced plasma by combining emission and absorption spectroscopy

Planar Laser Induced Fluorescence of OH for Thermometry in a Flow Field Based on Two Temperature Point Calibration Method

Measurements of CO2 Temperature and Concentration in High Temperature Environment Based on Tunable Diode Laser Absorption Spectroscopy

Determining the electron temperature in inductively coupled nitrogen plasmas by optical emission spectroscopy with molecular kinetic effects

Comparison of Temperature and Composition Measurement by Spectroscopic Methods for Argon–helium Arc Plasma

Determination of laser-induced plasma temperature

Spectroscopic Diagnostics of High-Temperature Laser-Produced Tungsten Plasmas Using the Comparison Method

Measurement of Flame Temperature Using Simultaneous Dual-line Atomic Absorption of Two Elements

Quantitative Analysis method of laser-induced breakdown spectroscopy based on temperature iterative correction of self-absorption effect

Measurement of Electron Density and Electron Temperature of a Cascaded Arc Plasma Using Laser Thomson Scattering Compared to an Optical Emission Spectroscopic Approach

Improving Data Stability and Prediction Accuracy in Laser-Induced Breakdown Spectroscopy by Utilizing A Combined Atomic and Ionic Line Algorithm

Experimental investigation on plasma temperature of Ca by laser-induced breakdown spectroscopy

Influence of Target Temperature on H Alpha Line of Laser-Induced Silicon Plasma in Air

Spectroscopic Measurement of Atmospheric-pressure Non-equilibrium Ar Plasma Using Continuum and Line Spectra

Intensity ratio of resonance lines as a diagnostic of initial conditions suitable for XUV laser action in recombining plasmas

Multi-species temperature and number density analysis of a laser-produced plasma using dual-comb spectroscopy

Spatial spectroscopic diagnose of the plasma produced from laser ablation of a KTA crystal

Identification of Three Weak Lines and Their Influences on Diagnostics of Electron Temperature and Density in Astrophysical Plasmas

Dual-laser-induced Breakdown Thermometry Via Sound Speed Measurement：A New Procedure for Improved Spatiotemporal Resolution.