Abstract:The mechanical property of the upper mantle is controlled by the rheological properties of olivine. Water has great influence on the mechanical properties of olivine. Results showed that different temperatures and iron contents have influence on the water solubility of olivine. Therefore, the water solubility experiment was conducted on olivine with different iron contents at different temperatures in this paper. The olivine single crystals used in this study include natural San Carlo olivine single crystal Fa(17), Fa(24.7) (Fe-no. =100 x molar Fe/( Mg + Fe) ) and synthetic olivine single crystal Fa(22). Experiments were performed at temperatures between 1273K and 1473K with 50K increments at a confining pressure of 300MPa in a gas medium apparatus with oxygen fugacity buffered by the Ni : NiO. After the test, the olivine single crystal was double polished along b-plane. The composition was measured by Electron Probe, the orientation was determined by Electron Backscattered Diffraction (EBSD) and the OH absorption spectra were recorded by infrared spectroscopy, respectively, for each of the single crystal. Results showed that, when the temperature changes from 1273K to 1473K, the water solubility of Fa(17) olivine varied from 600 to 1200 H/10(6) Si, Fa(17) olivine from 1000 to 1300 H/10(6) Si and the synthetic Fa(22) olivine from 500 to 900 H/10(6) Si, respectively. Therefore, the water solubility of the olivine with the same iron content increases with the increase of the temperature. The water solubility of the olivine at the same temperature increases with the increase of the iron content for natural San Carlo olivine. One percent increase in iron content resulted in ten percent increase in water solubility. In this paper, the water solubility in olivine at several Fe contents can be used to estimate the water storage in the upper mantle.

Three-dimensional Coherent X-Ray Diffraction Imaging of Molten Iron in Mantle Olivine at Nanoscale Resolution.

Determination of Phase Relations of the Olivine–ahrensite Transition in the Mg2SiO4–Fe2SiO4 System at 1740 K Using Modern Multi-Anvil Techniques

A First-Principles Molecular Dynamics Study of Molecular Hydrogen Diffusion in Fe-free Olivine

In situ X-ray diffraction studies of iron to Earth-core conditions

Experimental investigation on water solubility in olivine single crystal with different fe content

Real Time Observation Experiment on Olivine Phase Transformation

Large Scale and Quantum Accurate Molecular Dynamics Simulation:Liquid Iron under Extreme Condition

Using Synchrotron Multigrain X-ray Diffraction Techniques to Determine Iron-Alloy Phase Relations at Earth and Planetary Core Conditions

Re-configuration and Interaction of Hydrogen Sites in Olivine at High Temperature and High Pressure

Evolution of Microstructural Properties in Sheared Iron‐Rich Olivine

In situ studies of iron under pressure: New windows on the Earth's core

Experimental Study of Carbonate-Silicate-metal Equilibria at Pressures to 30 GPa: New Insights into Deep Volatile Cycles

Structural evolution of liquid silicates under conditions in Super-Earth interiors

Experimental observation of dynamic recrystallization in olivine

Experimental Study of Water Solubility in Iron Rich Olivine

Atomic-scale Chemical Imaging and Quantification of Metallic Alloy Structures by Energy-Dispersive X-ray Spectroscopy

Using Multigrain Crystallography to Explore the Microstructural Evolution of the α-Olivine to γ-Ringwoodite Transformation and ε-Mg2SiO4 at High Pressure and Temperature

Two‐stage Spin Transition of Iron in FeAl‐bearing Phase D at Lower Mantle

In situ 3D crystallographic characterization of deformation-induced martensitic transformation in a metastable Fe–Cr–Ni austenitic alloy by X-ray microtomography

Insights into core-mantle differentiation from bulk Earth melt simulations

Investigation of Chemical Interaction and Melting Using Laser-Heated Diamond Anvil Cell