Intramolecular and Lateral Intermolecular Hole Transfer at the Sensitized TiO2 Interface

Ke Hu,Kiyoshi C. D. Robson,Evan E. Beauvilliers,Eduardo Schott,Ximena Zarate,Ramiro Arratia-Perez,Curtis P. Berlinguette,Gerald J. Meyer
DOI: https://doi.org/10.1021/ja410647c
IF: 15
2014-01-01
Journal of the American Chemical Society
Abstract:Characterization of the redox properties of TiO2 interfaces sensitized to visible light by a series of cyclometalated ruthenium polypyridyl compounds containing both a terpyridyl ligand with three carboxylic acid/carboxylate or methyl ester groups for surface binding and a tridentate cyclometalated ligand with a conjugated triarylamine (NAr3) donor group is described. Spectroelectrochemical studies revealed non-Nernstian behavior with nonideality factors of 1.37 ± 0.08 for the Ru(III/II) couple and 1.15 ± 0.09 for the NAr3(•+/0) couple. Pulsed light excitation of the sensitized thin films resulted in rapid excited-state injection (k(inj) > 10(8) s(-1)) and in some cases hole transfer to NAr3 [TiO2(e(-))/Ru(III)-NAr3 → TiO2(e(-))/Ru(II)-NAr3(•+)]. The rate constants for charge recombination [TiO2(e(-))/Ru(III)-NAr3 → TiO2/Ru(II)-NAr3 or TiO2(e(-))/Ru(II)-NAr3(•+) → TiO2/Ru(II)-NAr3] were insensitive to the identity of the cyclometalated compound, while the open-circuit photovoltage was significantly larger for the compound with the highest quantum yield for hole transfer, behavior attributed to a larger dipole moment change (Δμ = 7.7 D). Visible-light excitation under conditions where the Ru(III) centers were oxidized resulted in injection into TiO2 [TiO2/Ru(III)-NAr3 + hν → TiO2(e(-))/Ru(III)-NAr3(•+)] followed by rapid back interfacial electron transfer to another oxidized compound that had not undergone excited-state injection [TiO2(e(-))/Ru(III)-NAr3 → TiO2/Ru(II)-NAr3]. The net effect was the photogeneration of equal numbers of fully reduced and fully oxidized compounds. Lateral intermolecular hole hopping (TiO2/Ru(II)-NAr3 + TiO2/Ru(III)-NAr3(•+) → 2TiO2/Ru(III)-NAr3) was observed spectroscopically and was modeled by Monte Carlo simulations that revealed an effective hole hopping rate of (130 ns)(-1).
What problem does this paper attempt to address?