Abstract:The gas-phase oxidative coupling of methanol and dimethylamine (DMA) was investigated using bimetallic gold-based catalysts in a packed bed reactor. The selective coupling reaction yields dimethylformamide (DMF), a useful solvent for many chemical industries. Characterization of AgAu/SiO 2 and PdAu/SiO 2 catalysts reveal changes to the crystal and electronic structures of the metals indicative of predominantly alloyed nanoparticles. These alloy phases catalyze the oxidative coupling reaction of methanol and DMA to proceed with high selectivity towards DMF at low temperatures, whereas monometallic Ag or Pd catalysts are unselective and monometallic Au catalysts are unreactive. For PdAu/SiO 2 catalysts, increasing dilution of Pd in Au during synthesis results in increased gravimetric reaction rates (by 25 times) and rates per mol Pd (by 663 times), until both gravimetric and per Pd rates decrease as Pd is increasingly diluted in Au. These results suggest there is an optimum surface Pd ensemble size for oxidative coupling reactions, and that isolated Pd atoms are likely unreactive for this chemistry. DMF selectivity increases from monometallic Pd to alloyed Pd (from 45% to >75%), consistent with increasing isolation of oxygen rich domains capable of successive C-H cleavages leading to total oxidation products. Kinetic measurements show low reaction orders for the methanol (0-0.2), dimethylamine (0.1-0.5), and oxygen (0.1-0.2) reactants, alluding to high surface coverages. Co-feeding H2O increased the rate of DMF formation, consistent with the increasingly basic surface adsorbates (i.e., hydroxyls) that are most reactive for kinetically relevant oxidative bond cleavages (e.g., C-H cleavage). DFT calculations and microkinetic modelling reveal surfaces of Pd(111) to be covered by surface oxygen and dehydrogenated DMA, the presence of which affect the reaction kinetics. Finally, at temperatures exceeding 448 K, a wide variety of additional products beyond DMF were detected by on-line mass spectrometry, including methyl formate, methyl dimethyl carbamate, and tetraemethyl urea. The observation of additional products provides the possibility that reported catalysts may produce a variety of chemicals in a single reactor depending on operating conditions.

DMF As Carbon Source: Rh-Catalyzed Α-Methylation of Ketones

N-heterocyclic Carbene Catalyzed Direct Carbonylation of Dimethylamine.

Electrooxidative α-hydroxymethylation of ketones with dimethylformamide as the carbon source

Selective Α‐monomethylation by an Amine‐Borane/N,N‐Dimethylformamide System As the Methyl Source

Direct Csp3–H methylenation of 2-arylacetamides using DMF/Me2NH-BH3 as the methylene source

Electrochemical formylation of aryl halides by using DMF as formyl source

Direct Transformation of N,N-Dimethylformamide to -Cn: Pd-Catalyzed Cyanation of Heteroarenes Via C-H Functionalization

Synthesizing Methyl Formate by Methanol Carbonylation Using DMF Promoter

Cu-mediated C–H Cyanation of Arenes Using N,N-dimethylformamide (DMF) As the “CN” Source

N,N-Dimethylformamide: A Multipurpose Building Block

Mn-Catalyzed Selective Double and Mono-N-Formylation and N-Methylation of Amines by Using CO2.

Can CO2 be a catalyst? Yes, CO2-catalyzed N-formylation of aliphatic amines with DMF

Catalyst-controlled and visible-light-induced acylmethylation and bromoacylmethylation of Morita-Baylis-Hillman acetates with a-bromo ketones: access to highly functionalized 1,5-dicarbonyl compounds

Boosting the catalytic activity via acid-base synergistic effect for CO2 and methanol direct to dimethyl carbonate

Selective Vapor-Phase Formation of Dimethylformamide via Oxidative Coupling of Methanol and Dimethylamine over Bimetallic Catalysts

KF-Catalyzed direct thiomethylation of carboxylic acids with DMSO to access methyl thioesters

Rh(III)‐catalyzed C6‐selective Acylmethylation and Carboxymethylation of 2‐Pyridones with Diazo Compounds

Electrochemical Direct Formyloxylation of Benzylic C(sp 3 )–H with DMF

Efficient DMF-assisted synthesis of formamides from amines using CO 2 catalyzed by heterogeneous metal-free imidazolium-hypercrosslinked polymers

Efficient DMF-assisted synthesis of formamides from amines using CO2 catalyzed by heterogeneous metal-free imidazolium-hypercrosslinked polymers

N,N‐Dimethylformamid: Ein Vielseitiger Baustein Für Die Synthese