Abstract:Objective: To introduce a technique of second order wave-shaped arch wire to orthodontically treat dental occlusal plane canting (DOPC) with left-right interactive anchorage, and to test its clinical efficacy. Methods: Among the permanent dentition malocclusion patients who showed no obvious facial asymmetry, we screened for patients who showed anterior occlusal plane canting (AOPC) after routine orthodontic examination, treatment planning, MBT fixed appliance installation and serial arch wires alignment. Each patient had been clinically appraised in frontal view by 2 orthodontists and the patient him/herself; if all 3 agreed that the AOPC was obvious, the patient was included. By this means, we included 37 patients, including 10 males and 27 females; the average age was (21.9±5.2) years. To correct AOPC, opposite direction equal curvature second order rocking-chair curve was bent on each side of 0.46 mm×0.56 mm stainless steel edgewise wire. With reference to normal occlusal plane, a curve toward the occlusal surface was made to extrude under-erupted teeth on one side while a curve toward the gingiva was made to intrude over-erupted teeth on the other side, so that the arch wire was made into a wave shape in vertical dimension. Before and after application of wave-shaped arch wire, frontal facial photographs were taken when the patient's mouth was open slightly with lips retracted to show anterior occlusal plane (AOP) clearly. An AOP was constructed by connecting the center of the slot in the medial edge of canine bracket on each side in the photograph. The angles between the bipupillary plane(BPP) and the constructed AOP were measured in ImageJ1-48v software and the angle differences before and after treatment were compared with paired Wilcoxon test in SPSS 10.0 software. Results: The wave-shaped arch could correct AOPC effectively in 3 to 10 months time with an average of 5.5±1.7 months; the angles between AOP and BBP before treatment ranged from 2.90° to 6.12° with a median of 4.01°; after treatment the angles were from -0.17° to 2.57° with a median of 1.87°, the decrease of the angles between AOP and BBP after treatment ranged from 1.08° to 4.15° with a median of 2.21°. Paired Wilcoxon test P was 0.000. Conclusion: The wave-shaped arch can be used independently or in combination with other treatment methods, which can take advantage of left and right interactive anchorage to correct AOPC effectively, so it has certain application value in clinical practice.

[Research of Cranio-Occlusional Change of Skeletal Class III Malocclusion in Permanent Dentition Treated by the Multiloop Edgewise Arch Wire Technique].

Research of cranio-occlusional change of arch asymmetry malocclusion in permanent dentition treated by the multiloop edgewise arch wire technique

CEPHALOMETRIC ANALYSIS ON THE TREAMENT OF SKELETAL CLASS Ⅲ MALOCCLUSION BY MULTILOOP EDGEWISE ARCH WIRE TECHNIQUE

The Stability Guided Multidisciplinary Treatment of Skeletal Class III Malocclusion Involving Impacted Canines and Thin Periodontal Biotype: A Case Report with Eight-Year Follow-Up.

Treatment of Skeletal Class Ⅲ Patients of High Angle with Microscrew Implant Anchorage and Multi loop Edgewise Arch Wire

Treatment Effects of MEAW with Straight Wire Appliance in Open Bite

Treatment of Open Bite with Multiloop Edgewise Arch Wire Technique

Study of changes of condylar morphology and position by MRI with fixed inclined bite-plate therapy in mandibule-retrusion patients

Treatment effects of MEAWtherapy on skeletal class Ⅲ Malocclusion

Cephalometric evaluation of the anterior open bite treatment

Preliminary investigation of nonsurgical treatment of severe skeletal Class III malocclusion in the permanent dentition.

[Preliminary Investigation of Lower Second Molar Extraction in Correction of Severe Skeletal Class III Malocclusion].

Developing Skeletal Class III Malocclusion Treated Nonsurgically with a Combination of a Protraction Facemask and a Multiloop Edgewise Archwire.

Lower Second Molar Extraction in Correction of Severe Skeletal Class Iii Malocclusion

[A new method to orthodontically correct dental occlusal plane canting: wave-shaped arch]

Class Ⅲ Malocclusion Treated by Second Premolar Extraction

[Preliminary Study of Non-Surgical Treatment of Severe Class III Malocclusion in 18 Patients of 12-20 Years Old].

Effect of alternate maxillary expansions and constrictions with lighter force of maxillary protraction in treatment of Class Ⅲ malocclusions

Comparative Analysis of Skeletal Changes, Occlusal Changes, and Palatal Morphology in Children with Mild Class III Malocclusion Treated with Elastodontic Appliances and Bimaxillary Plates

[Three-Dimensional Analysis of the Early Correction of Anterior Crossbite Using Eruption Guidance Appliance].

Comparison of two types of biomecanics for deep overbite correction