Abstract:We propose a novel laser configuration that can output 3.5-$\mu$m nanosecond laser pulses based on a simple and monolithic fiber structure. Cascade-gain-switching, which converts the wavelength of nanosecond pulses from 1.55 $\mu$m to 3.5 $\mu$m by two successive gain-switching processes. Instead of using expensive pump sources at special wavelengths and bulky active or passive modulation elements for Q-switching or mode-locking, the cascade gain-switching only requires the pumping of an electric-modulated 1.55-$\mu$m pulsed laser and two continuous-wave (CW) 975-nm laser diodes. They are all standard products for fiber optic communication applications, which can greatly lower the cost of mid-infrared laser pulse generation. To investigate the feasibility of this configuration, we numerically simulated the cascade-gain-switching processes by comprehensive rate-equation models. In single-shot regime, for stable 3.5-$\mu$m pulsed lasing, the CW 975-nm pump should be turned on at least $\sim500$ $\mu$s ahead of the 1.55-$\mu$m pulsed pump. It shows that the pulse width of the 1.55-$\mu$m pump has major impact on the temporal shape of the intermediate 1.97-$\mu$m pulse while has neglected influence on the generated 3.5-$\mu$m pulse. On the other hand, increasing the CW pump power can significantly improve the output peak power and shorten the pulse when the pump power is less than $\sim4$ W. In the repetitive-pulse regime, we found the 3.5-$\mu$m pulse train can be stably outputted when the repetition rate is $<=100$ kHz. As the repetition rate increases, the duration of reaching the stable operation increases. When the repetition rate is large than 100 kHz, the stable operation cannot be established because the rate of consuming the population on the $^4I_{11/2}$ level of $Er^{3+}$ ions is faster than the rate of building the population.

Q-switched Induced Gain Switching of a Two-Transition Cascade Laser.

Cascade-gain-switching for generating 3 . 5-μ m nanosecond pulses from low-cost monolithic fiber lasers

Cascade-gain-switching for generating 3.5-um nanosecond pulses from monolithic low-cost fiber lasers

2 W Quasi-White-light Based on Idler-Resonant Optical Parametric Oscillation Cascading Sum-Frequency Generation with PPSLT

Compact Passively Q-switched Green Laser with Periodically Poled MgO:LiNbO 3

Investigation Of Regime Switching From Mode Locking To Q-Switching In A 2 Mu M Ingasb/Gaassb Quantum Well Laser

InGaAsP/InP Based Q-modulated Slotted Fabry-Perot Laser Employing Lossy Half-Wave Trenches

Few ns Pulse Duration of Gain-Switched Ho:YAG Laser Pumped by an Active Q-Switched Tm:YLF Laser

High-Peak-Power Passively Q-Switched Laser at 589 nm with Intracavity Stimulated Raman Scattering

Intra-cavity Cascaded Pumped 912nm/1030 Nm Dual Wavelength Laser Output

The passive Q-switching Tm, Ho co-doped GAGG state laser operating near 2.1 μm

Passive Q-switched Operation of a LD-pumped Nd:YVO4 Laser with GaAs As a Passive Q-switched Component and Output Coupler

Q-switched pulse generation by stimulated Brillouin scattering assisted four-wave mixing effect in erbium–bismuth co-doped multi-elements silica glass based optical fiber laser

Nanosecond Self-Q-Switching Nd:Luag Laser with High Repetition Rate

High Power Self-Q-Switching in Nd:LuAG Laser

Sub-MHz Self-Q-switching in Nd:LuAG Laser

Laser Diode-Pumped Passively Q-Switched Monolithic Microchip Laser Based on Liquid Phase Epitaxy

LD-pumped Q-switched self-frequency-doubling laser

Fast Gain Dynamics in Interband Cascade Lasers

Diode-Pumped Nanosecond Pulsed Laser With Pulse-Transmission-Mode Q-Switch

Ti : Sapphire Laser Pumped Cr4+,Nd3+: Yag Self-Q-Switched Microchip Laser