In situ hydrothermal grown silicalite-1 coating for solid-phase microextraction.

Heyun Fu,Dongqiang Zhu

DOI: https://doi.org/10.1021/ac203119k

IF: 7.4

2012-01-01

Analytical Chemistry

Abstract:A novel fiber coated with silicalite-1 for solid-phase microextraction (SPME) was prepared by in situ hydrothermal growth method. Six substituted benzenes (nitrobenzene, p-dichlorobenzene, m-dichlorobenzene, 1,3,5-trichlorobenzene, p-chloronitrobenzene, and m-chloronitrobenzene) were employed as model analytes. The fiber exhibited high thermal stability (little weight loss up to 600 degrees C) and high chemical stability (no loss of function after sequential immersion in 0.1 M HCl, 0.01 M NaOH, methanol, and n-hexane each for at least 4 h). Compared with commercial fibers, 3-6 times higher extraction efficiencies were shown on the fiber for mono- and p-substituted benzenes. Under the preoptimized conditions, the fiber afforded satisfactory enhancement factors (517-1292), wide linear ranges (more than 2 orders of magnitude), low limits of detection (0.001-0.130 mu g/L), and acceptable repeatability (<9.6%) and reproducibility (<8.8%). Furthermore, the fiber offered distinct shape-selectivity attributed to the uniform molecular-scale pore structure of silicalite-1. The ratios of extraction were approximately 70 between p-dichlorobenzene and 1,3,5-trichlorobenzene, 30 between p-chloronitrobenzene and m-chloronitrobenzene, and 3 between p-dichlorobenzene and m-dichlorobenzene. After pore narrowing by surface modification with SiCl4, the selectivity for p-dichlorobenzene over m-dichlorobenzene was further enhanced by another 10 times. Finally, the fiber was successfully applied to analysis of a real water sample.