Abstract:Two methacrylate monomers, oligo(ethylene glycol) methyl ether methacrylate (OEGMA; MW=300gmol−1, poly(ethylene glycol) (PEG) side chains of average length n=4.5) and 2-methacryloyloxyethyl phosphorylcholine (MPC; MW=295gmol−1), were grafted from silicon wafer surfaces via surface-initiated atom transfer radical polymerization. The grafted surfaces were used as model PEG and phosphorylcholine surface systems to allow comparison of the effectiveness of these two motifs in the prevention of plasma protein adsorption and platelet adhesion. It was found that at high graft density fibrinogen adsorption from plasma on the poly(MPC) and poly(OEGMA) surfaces for a given graft chain length was comparable and extremely low. At low graft density, poly(OEGMA) was slightly more effective than poly(MPC) in resisting fibrinogen adsorption from plasma. Flowing whole blood experiments showed that at low graft density the poly(OEGMA) surfaces were more resistant to fibrinogen adsorption and platelet adhesion than the poly(MPC) surfaces. At high graft density, both the poly(MPC) and poly(OEGMA) surfaces were highly resistant to fibrinogen and platelets. Immunoblots of proteins eluted from the surfaces after contact with human plasma were probed with antibodies against a range of proteins, including the contact phase clotting factors, fibrinogen, albumin, complement C3, IgG, vitronectin and apolipoprotein A-I. The blot responses were weak on the poly(MPC) and poly(OEGMA) surfaces at low graft density and zero at high graft density, again indicating strongly protein resistant properties for these surfaces. Since the side chains of the poly(OEGMA) are about 50% greater in size than those of poly(MPC), the difference in protein resistance between the poly(MPC) and poly(OEGMA) surfaces at low graft density may be due to the difference in surface coverage of the two graft types.

Study on antithrombogenicity of poly[beta-(acetylsalicylyloxy)ethyl methacrylate] relative to poly(hydroxyethyl methacrylate).

Antiplatelet and Thermally Responsive Poly(N-Isopropylacrylamide) Surface with Nanoscale Topography

Engineering of hemocompatible and antifouling polyethersulfone membranes by blending with heparin-mimicking microgels

Methacrylate polymer layers bearing poly(ethylene oxide) and phosphorylcholine side chains as non-fouling surfaces: in vitro interactions with plasma proteins and platelets.

STUDIES OF NEW-TYPE HEPARINIZED POLYSTYRENE FILM SURFACES AND THEIR ANTITHROMBOGENICITY IN VITRO

Covalently-Attached, Surface-Eroding Polymer Coatings on Magnesium Alloys for Corrosion Control and Temporally Varying Support of Cell Adhesion

Preparation and Biological Evaluations of Heparinized PLLA Films

Synthesis and evaluation of poly(hexamethylene-urethane) and PEG-poly(hexamethylene-urethane) and their cholesteryl oleyl carbonate composites for human blood biocompatibility

Monoether-Tagged Biodegradable Polycarbonate Preventing Platelet Adhesion and Demonstrating Vascular Cell Adhesion: A Promising Material for Resorbable Vascular Grafts and Stents

Antithrombogenic polysaccharide coatings to improve hemocompatibility, protein-repellence, and endothelial cell response

[A Water-Soluble Synthetic Polymer, Alpha,beta-Poly(hydroxyalkyl)-dl-asparamide, and Conjugating Drug].

Polycarbonate Urethane Films Modified by Heparin to Enhance Hemocompatibility and Endothelialization

Incorporating Anticoagulant and Antiplatelet Dual Functional Groups into Thermosetting Polymer Chain for Enhancing Antithrombogenicity

In vitro blood compatibility of functional group-grafted and heparin-immobilized polyurethanes prepared by plasma glow discharge

In Vitro Platelet Adhesion of PNaAMPS/PAAm and PNaAMPS/PDMAAm Double‐Network Hydrogels

Construction of anticoagulant poly (lactic acid) films via surface covalent graft of heparin-carrying microcapsules

In vitro study on hemocompatibility and cytocompatibility of poly(3-hydroxybutyrate-co -3-hydroxyhexanoate)

Platelet adhesion to human umbilical vein endothelial cells cultured on anionic hydrogel scaffolds

Flexible inner surface of polysulfone membranes prevents platelet adhesive protein adsorption and improves antithrombogenicity in vitro

Dual surface modification of polydimethylsiloxane (PDMS) with antithrombin-heparin complex (ATH) and tissue plasminogen activator (t-PA) for enhanced antithrombotic activity

Study on the Synthesis and Properties of the Copolymer of Allyl-Terminated Poly (Γ-Benzyl-l-glutamate) and 2-Methacryloyloxyethyl Phosphorycholine