Abstract:Dome A 5m Terahertz Explorer (DATE5) is a proposed telescope to be deployed at Dome A, Antarctica to explore the excellent terahertz observation condition unique to the site. One of the key challenges of the telescope is to realize and maintain the required 10 mu m rms overall reflector surface accuracy under the extreme site conditions and unmanned operating mode. Aluminum panels on carbon fiber backup structures is one of the candidate options for the 5 meter main reflector. For aluminum panels, three major technical risks were identified: 1) the large CTE of aluminum causes significant panel deformation due to the large seasonal soak temperature change; 2) internal stress may cause additional surface deformation when operating under a cold environment; 3) reflector panels working at Dome A run high risks of icing (which degrades antenna efficiency and increases noise) and automatic active de-icing mechanisms has to be implemented on the panels. In order to verify the feasibility of the aluminum panels for DATE5 and identify possible technical risks, a prototype panel was fabricated and went through rigorous tests. The manufacture error at the room temperature is 3.2 mu m rms, which meets the budget. The panel surface is then measured at various ambient temperatures down to -60 degrees C in a climate chamber using photogrammetric techniques. The additional surface error at the low temperatures is found to be mainly contributed by defocusing error, and the dependence of the panel focal length on temperature is well predictable. No additional surface error caused by internal stress has been observed. Next, the icing condition of the panel is analyzed and a prototype de-icing system based on polyimide film heaters was installed on the panel. The performance of the de-icing system was tested in a climate chamber as well as in the field experiments to simulate a variety of operating environments. The experiments indicate that the power required for de-icing the entire main reflector is less than 1kW and the temperature field produced by the de-icing system has trivial effect on the surface accuracy of the panel. This study indicates that aluminum panels have the potential to meet the reflector surface error budget under the harsh environment of Dome A.

Study on the Optics of the 5 Meter Dome A Terahertz Explorer (DATE5) for Antarctica

Initial Considerations of the 5 Meter Dome A Terahertz Explorer (date5) for Antarctica

Design Study on Near-Field Radio Holography of the 5-Meter Dome A Terahertz Explorer

Conceptual Design Studies of the 5 M Terahertz Antenna for Dome A, Antarctica

Mode analysis of the 5 meter Terahertz antenna for Dome A, Antarctica

Research on high precision antenna for DATE5

A THz Superconducting Imaging Array Developed for the DATE5 Telescope

Gravity Loading Effect Analysis of the 5 Meter Terahertz Antenna for Dome A, Antarctica

Accuracy Analysis of the Pointing and Focusing Calibration of the 5 M Terahertz Telescope for Dome A in Antarcticatwo

THz atmospheric transmission measured at antarctic Dome A

Prototyping And Environmental Experiments Of An Aluminum Panel For The Dome A 5m Terahertz Explorer (Date5)

Astronomy from Dome A in Antarctica

Dome A Site Testing and Future Plans

Experimental Studies On Near-Field Holographic Antenna Measurement

A Fourier Transform Spectrometer for Site Testing at Dome A

Atmospheric Windows from Dome-A Antarctica for High Angular Resolution Terahertz Astronomy

Dome A, Antarctica: Prospectives for terahertz astronomy from the ground

Performance of the Second Antarctic Survey Telescope at Dome A

Optical System of the Three Antarctic Survey Telescopes

A THz FTS for site testing at dome A

Terahertz Atmospheric Windows for High Angular Resolution Terahertz Astronomy from Dome A